Abstract:We report a type of multimode fiber interferometers (MMI) formed in photonic crystal fiber (PCF). To excite the cladding modes from the fundamental core mode of a PCF, a coupling point is formed. To form the coupling point, we used the method that is blowing compressed gas into the air-holes and discharging at one point, and the air-holes in this point will expand due to gas expansion in the discharge process. By placing two coupling points in series, a very simple all-fiber MMI can be implemented. The detailed fabrication process is that the one end of the PCF is tightly sealed by a short section of single mode fiber (SMF) spliced to the PCF. The other end of the PCF is sealed into a gas chamber and the opened air holes are pressurized. The PCF is then heated locally by the fusion splicer and the holes with higher gas pressure will expand locally where two bubbles formed. We tested the RI responses of fabricated sensors at room temperature by immersing the sensor into solutions with different NaCl concentration. Experimental results show that as refractive-index (RI) increases, the resonance wavelength of the MMI moves toward longer wavelengths. The sensitivity coefficients are estimated by the linear fitting line, which is 46nm/RIU, 154mn/RIU with the interferometer lengths (IL) of 3mm and 6mm. The interferometer with larger IL has higher RI sensitivity. The temperature cross-sensitivity of the sensor is also tested. The temperature sensitivity can be as low as -16.0pm/degrees C.

Refractive index measurement using photonic crystal fiber-based Fabry-Perot interferometer.

Optofluidic Refractive Index Sensor Based on Partial Reflection

High-sensitivity refractive index sensors based on fused tapered photonic crystal fiber

All-Fiber Fabry-Perot Interferometer Gas Refractive Index Sensor Based on Hole-Assisted One-Core Fiber and Vernier Effect

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

Hybrid Fabry-Perot Interferometer for Simultaneous Liquid Refractive Index and Temperature Measurement

Refractive Index Sensing Characteristic of A Hybrid-Fabry-Perot Interferometer Based on an In-Fiber Ellipsoidal Cavity

Highly Sensitive Refractive Index Sensor Based on an In-Fiber Droplet-Shape Air-Cavity

Fiber Optic Sensor for Simultaneous Measurement of Refractive Index and Temperature Based on Internal-and- External-Cavity Fabry–Pérot Interferometer Configuration

Refractive Index Sensor Using Microfiber-Based Mach-Zehnder Interferometer

Optical Fiber Sensor Based on Capillary Wall for Highly-Sensitive Refractive Index Measurement

Open-Cavity Fabry-Perot Interferometer Based on Etched Side-Hole Fiber for Microfluidic Sensing

Ultra compact and sensitive optical fiber interferometric refractive index sensor

A Refractive Index Sensor Based on Four-Wave Mixing in D-Shaped Tellurite Photonic Crystal Fiber

Photonic crystal fiber refractive-index sensor based on multimode interferometry

All In-Fiber Fabry–Pérot Interferometer Sensor Towards Refractive Index and Temperature Simultaneous Sensing

A novel D-shaped photonic crystal fiber refractive index sensor based on surface plasmon resonance effect

Multi-Point Fiber-Optic Refractive Index Sensor by Using Coreless Fibers

[Synthesis of poly U by RNA polymerase with octoadenylic acid (hepta adenylyl-(3',5')-adenosine) as a template].

Refractive Index Sensors Based on a Chirped Core Long-Period Fiber Grating