Abstract:We report a type of multimode fiber interferometers (MMI) formed in photonic crystal fiber (PCF). To excite the cladding modes from the fundamental core mode of a PCF, a coupling point is formed. To form the coupling point, we used the method that is blowing compressed gas into the air-holes and discharging at one point, and the air-holes in this point will expand due to gas expansion in the discharge process. By placing two coupling points in series, a very simple all-fiber MMI can be implemented. The detailed fabrication process is that the one end of the PCF is tightly sealed by a short section of single mode fiber (SMF) spliced to the PCF. The other end of the PCF is sealed into a gas chamber and the opened air holes are pressurized. The PCF is then heated locally by the fusion splicer and the holes with higher gas pressure will expand locally where two bubbles formed. We tested the RI responses of fabricated sensors at room temperature by immersing the sensor into solutions with different NaCl concentration. Experimental results show that as refractive-index (RI) increases, the resonance wavelength of the MMI moves toward longer wavelengths. The sensitivity coefficients are estimated by the linear fitting line, which is 46nm/RIU, 154mn/RIU with the interferometer lengths (IL) of 3mm and 6mm. The interferometer with larger IL has higher RI sensitivity. The temperature cross-sensitivity of the sensor is also tested. The temperature sensitivity can be as low as -16.0pm/degrees C.

A Reflective Fiber-Optic Refractive Index Sensor Based on Multimode Interference in A Coreless Silica Fiber

Optofluidic Refractive Index Sensor Based on Partial Reflection

Multi-Point Fiber-Optic Refractive Index Sensor by Using Coreless Fibers

[Synthesis of poly U by RNA polymerase with octoadenylic acid (hepta adenylyl-(3',5')-adenosine) as a template].

Refractive Index Sensor Based on No-Core Fiber With Optoelectronic Oscillator Interrogation

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

Refractive Index Sensor Using Microfiber-Based Mach-Zehnder Interferometer

A Compact Refractive Index Sensor with High Sensitivity Based on Multimode Interference

Refractive index sensors based on the fused tapered special multi-mode fiber

High Sensitivity Evanescent Field Refractometer Based on Modal Interference in Micro-Capillary Wall

Miniature Single-Mode Fiber Refractive Index Interferometer Sensor Based on High Order Cladding Mode and Core-Offset

Highly Sensitive Refractive Index Sensor Based on a Cladding-Etched Thin-Core Fiber Sandwiched Between Two Single-Mode Fibers

Research on High Sensitive Refractive Index Sensor Based on D-Single Mode Fiber

Photonic crystal fiber refractive-index sensor based on multimode interferometry

Highly Sensitive Refractive Index Sensor Based on an In-Fiber Droplet-Shape Air-Cavity

Optical Fiber Sensor Based on Capillary Wall for Highly-Sensitive Refractive Index Measurement

Fiber Optic Sensor for Simultaneous Measurement of Refractive Index and Temperature Based on Internal-and- External-Cavity Fabry–Pérot Interferometer Configuration

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Improved optical fiber Mach-Zehnder high-sensitivity refractive index sensor

A highly sensitive four-wave mixing-based microstructured fiber refractive index sensor for microfluid sensing applications

Optical Refractive-Index Sensor Based on Dual Fiber-Bragg Gratings Interposed with a Multimode-Fiber Taper