Abstract:A novel fiber-optic refractive index (RI) sensor based on a splicing point tapered fiber Michelson interferometer is proposed. It consists of a short section of thin-core fiber (TCF), which is spliced to a standard single-mode fiber, then the fused region is drawn into a taper by using residual heat. The interference between the core and cladding modes in the TCF is utilized, which is insensitive to variations in the RI of the surrounding environment but susceptible to external temperature changes. However, owing to the Fresnel reflection on the fiber end face, the intensity of the reflection spectrum decreases with increasing RI of the surrounding environment. Thus, the RI and temperature can be demodulated by the intensity and wavelength of the reflection spectrum, respectively, which can eliminate the crosstalk between RI and temperature. We experimentally found that the sensor has RI sensitivity of up to 68.60 dB/RIU for a TCF length of 10 mm and a waist diameter of 50 mu m. The temperature characteristics of the sensor in the range of 30 to 90 degrees C were also investigated, and a sensitivity of about 57 pm/degrees C was obtained. Moreover, the compact size, easy fabrication, and low cost of the proposed fiber-optic RI sensor make it an attractive device.

Miniature Single-Mode Fiber Refractive Index Interferometer Sensor Based on High Order Cladding Mode and Core-Offset

Sensitive refractive index sensor based on an assembly-free fiber multi-mode interferometer fabricated by femtosecond laser

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

A Compact Refractive Index Sensor with High Sensitivity Based on Multimode Interference

Highly Sensitive Refractive Index Sensor Based on a Cladding-Etched Thin-Core Fiber Sandwiched Between Two Single-Mode Fibers

Highly Sensitive Refractive Index Sensor Based on Novel Mach–Zehnder Interferometer with Multimode Fiber–thin Core Fiber–multimode Fiber Structure

Simultaneous Measurement of Refractive Index and Temperature Using a Mach-Zehnder Interferometer with Forward Core-Cladding-core Recoupling

Multi-Point Fiber-Optic Refractive Index Sensor by Using Coreless Fibers

A Miniature Fiber-Optic Refractive-Index Sensor Based on Laser-Machined Fabry-Perot Interferometer Tip

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

High Sensitive Refractive Index Sensor Based on Cladding Etched Photonic Crystal Fiber Mach-Zehnder Interferometer

A Single-Mode Fiber Sensor Based on Core-Offset Inter-Modal Interferometer

Miniature fiber-optic near-surface gap-coupled cladding waveguide Mach-Zehnder interferometric refractive index sensor inscribed by femtosecond laser

Dual Mach–Zehnder Interferometer Based on Side-Hole Fiber for High-Sensitivity Refractive Index Sensing

Refractive index sensor based on ultrafine tapered single-mode nocladding single-mode fiber structure

Highly Sensitive Refractive Index Sensor Based on an In-Fiber Droplet-Shape Air-Cavity

Refractive Index Sensor Using Microfiber-Based Mach-Zehnder Interferometer

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

Refractive Index Sensors Based on a Chirped Core Long-Period Fiber Grating