Abstract:A high sensitivity liquid refractive index (RI) sensor based on a single mode fiber-multimode fiber-tapered thin-core fiber-single mode fiber (SMTTS) structure is simulated by the beam propagation method (BPM). The modal interference between core and cladding mode happened because of modal mismatch and the transmission spectrum is calculated by BPM. The approximate linear relationship between liquid RI and spectrum dip wavelength shifts is obtained to demodulate RI value. To make a comparison, transmissions of single mode fiber-thin-core fiber-single mode fiber (STS) as well as single mode fiber-multimode fiber-thin-core fiber-single mode fiber (SMTS) are also calculated. It is significantly shown that the interference is improved by the segment of multimode fiber (M_MF). And the tapered thin-core fiber (TCF) has the functions that not only further can enhance the fringe visibility, but also can increase the RI sensitivity, which is higher with the thinner thin-core taper diameter. When the taper diameter is 53.51m, the average RI sensitivity could reach up to -116.7nm/RIU within the RI range of 1.33 to 1.39. This is much higher than the value of SMTS structure. And in the practice application, it could be a slimmer taper in the SMTTS structure to improve the sensitivity just achieving by a simple fabrication process. All process could be finished using fusion splicer, cutter and hydrogen flame.

Refractive index sensors based on the fused tapered special multi-mode fiber

Fiber-Optic Refractive Index Sensor Based on Multi-Tapered SMS Fiber Structure

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

High-sensitivity refractive index sensors based on fused tapered photonic crystal fiber

High Sensitivity Refractive Index Sensor Based On Tapered Thin-Core Fiber

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

High Sensitivity Refractive Index Sensor based on a Tapered Single-mode-Multimode-Single-mode Fiber Structure

A High-Sensitivity SPR Sensor Based on MMF-Tapered HCF-MMF Fiber Structure for Refractive Index Sensing

Refractive index sensor based on ultrafine tapered single-mode nocladding single-mode fiber structure

High Sensitivity Evanescent Field Refractometer Based on Modal Interference in Micro-Capillary Wall

High Sensitivity Balloon-Like Refractometric Sensor Based on Singlemode-Tapered Multimode-Singlemode Fiber

A Compact Refractive Index Sensor with High Sensitivity Based on Multimode Interference

Highly Sensitive Refractive Index Sensor Based on Novel Mach–Zehnder Interferometer with Multimode Fiber–thin Core Fiber–multimode Fiber Structure

An Interferometric Dual Microfiber Refractive Index Sensor via Tapering of Femtosecond Laser Perforated Optical Fiber

Optical Refractive-Index Sensor Based on Dual Fiber-Bragg Gratings Interposed with a Multimode-Fiber Taper

S-Tapered Fiber Sensors for Highly Sensitive Measurement of Refractive Index and Axial Strain

Balloon-like Singlemode-Tapered Multimode-Singlemode Fiber Structure for Refractive Index Sensing

A Reflective Fiber-Optic Refractive Index Sensor Based on Multimode Interference in A Coreless Silica Fiber

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Improvement on Refractive Index Sensing by Exploiting the Tapered Two-Mode Fibers