Abstract:Due to the pristine interface of the 2D/3D face-tunneling heterostructure with an ultra-sharp doping profile, the 2D/3D tunneling field-effect transistor (TFET) is considered as one of the most promising low-power devices that can simultane-ously obtain low off-state current (IOFF), high on-state current (ION) and steep subthreshold swing (SS). As a key element for the 2D/3D TFET, the intensive exploration of the tunnel diode based on the 2D/3D heterostructure is in urgent need. The transfer technique composed of the exfoliation and the release process is currently the most common approach to fabri-cating the 2D/3D heterostructures. However, the well-established transfer technique of the 2D materials is still unavailable. Only a small part of the irregular films can usually be obtained by mechanical exfoliation, while the choice of the chemical exfoliation may lead to the contamination of the 2D material films by the ions in the chemical etchants. Moreover, the defor-mation of the 2D material in the transfer process due to its soft nature also leads to the nonuniformity of the transferred film, which is one of the main reasons for the presence of the wrinkles and the stacks in the transferred film. Thus, the large-scale fabrication of the high-quality 2D/3D tunnel diodes is limited. In this article, a comprehensive transfer technique that can mend up the shortages mentioned above with the aid of the water and the thermal release tape (TRT) is proposed. Based on the method we proposed, the MoS2/Si tunnel diode is experimentally demonstrated and the transferred monolayer MoS2 film with the relatively high crystal quality is confirmed by atomic force microscopy (AFM), scanning electron microscopy (SEM), and Raman characterizations. Besides, the prominent negative differential resistance (NDR) effect is observed at room temperature, which verifies the relatively high quality of the MoS2/Si heterojunction. The bilayer MoS2/Si tunnel diode is also experimentally fabricated by repeating the transfer process we proposed, followed by the specific analysis of the electrical characteristics. This study shows the advantages of the transfer technique we proposed and indicates the great application foreground of the fabricated 2D/3D heterostructure for ultralow-power tunneling devices.

Silicon Surface Tunnel Transistor

Multi-state Tunnel Field Effect Transistor Based on Face Tunneling with Gate-Source Overlap

Lateral interband tunneling transistor in silicon-on-insulator

A Silicon Nanocrystal Tunnel Field Effect Transistor

MoS2/Si Tunnel Diodes Based on Comprehensive Transfer Technique

Microelectronic current-sourcing device based on band-to-band tunneling current

2D Short‐Channel Tunneling Transistor Relying on Dual‐Gate Modulation for Integrated Circuits Application

A Silicon Cluster Based Single Electron Transistor with Potential Room-Temperature Switching

Characteristic Enhancement in Tunnel Field-Effect Transistors Via Introduction of Vertical Graded Source

Silicon Cross-coupled Gated Tunneling Diodes

A Novel Planar InAs/Si Hetero-TFET with Buried Drain Design and Face-tunneling Technique

Device Physics and Design of a L-Shaped Germanium Source Tunneling Transistor

Normally-off trench JFET technology in 4H silicon carbide

A metal/oxide tunneling transistor

Characteristics of InAs/GaSb Line-Tunneling FETs with Buried Drain Technique

A subthermionic tunnel field-effect transistor with an atomically thin channel

Design of AlInAs/InP Tunnel Junction and Its Application in Devices

High-Current-Density Vertical-Tunneling Transistors from Graphene/Highly Doped Silicon Heterostructures

Monte Carlo Simulation of Band-to-band Tunneling in Silicon Devices

Tunable Band Gap and Doping Type in Silicene by Surface Adsorption: Towards Tunneling Transistors.

Experimental Investigation of a Novel Junction-Modulated Hetero-Layer Tunnel FET with the Striped Gate for Low Power Applications.