Abstract:Due to the pristine interface of the 2D/3D face-tunneling heterostructure with an ultra-sharp doping profile, the 2D/3D tunneling field-effect transistor (TFET) is considered as one of the most promising low-power devices that can simultane-ously obtain low off-state current (IOFF), high on-state current (ION) and steep subthreshold swing (SS). As a key element for the 2D/3D TFET, the intensive exploration of the tunnel diode based on the 2D/3D heterostructure is in urgent need. The transfer technique composed of the exfoliation and the release process is currently the most common approach to fabri-cating the 2D/3D heterostructures. However, the well-established transfer technique of the 2D materials is still unavailable. Only a small part of the irregular films can usually be obtained by mechanical exfoliation, while the choice of the chemical exfoliation may lead to the contamination of the 2D material films by the ions in the chemical etchants. Moreover, the defor-mation of the 2D material in the transfer process due to its soft nature also leads to the nonuniformity of the transferred film, which is one of the main reasons for the presence of the wrinkles and the stacks in the transferred film. Thus, the large-scale fabrication of the high-quality 2D/3D tunnel diodes is limited. In this article, a comprehensive transfer technique that can mend up the shortages mentioned above with the aid of the water and the thermal release tape (TRT) is proposed. Based on the method we proposed, the MoS2/Si tunnel diode is experimentally demonstrated and the transferred monolayer MoS2 film with the relatively high crystal quality is confirmed by atomic force microscopy (AFM), scanning electron microscopy (SEM), and Raman characterizations. Besides, the prominent negative differential resistance (NDR) effect is observed at room temperature, which verifies the relatively high quality of the MoS2/Si heterojunction. The bilayer MoS2/Si tunnel diode is also experimentally fabricated by repeating the transfer process we proposed, followed by the specific analysis of the electrical characteristics. This study shows the advantages of the transfer technique we proposed and indicates the great application foreground of the fabricated 2D/3D heterostructure for ultralow-power tunneling devices.

Silicon Cross-coupled Gated Tunneling Diodes

Self-rectifying Memristors with High Rectification Ratio and Dynamic Linearity for In-Memory Computing

Design of a Novel One Transistor-Dram Based on Bulk Silicon Substrate

Silicon Surface Tunnel Transistor

MoS2/Si Tunnel Diodes Based on Comprehensive Transfer Technique

A monolithically integrated Si interband tunneling diode (IBTD)/MOSFET memory for ultra low voltage operation below 0.5 V

Robust 6T Si tunneling transistor SRAM design

RRAM Mirrored and RRAM-Transistor Hybrid Single Device Logic Gates Based on Two-Dimensional Materials

Projected performance of Si- and 2D-material-based SRAM circuits ranging from 16 nm to 1 nm technology nodes

Design of a Novel High Speed Embedded DRAM

Highly Area-Efficient Low-Power SRAM Cell with 2 Transistors and 2 Resistors

A Semi-Floating Gate Memory Based on SOI Substrate by TCAD Simulation

Design and Analysis of Si/GaSb HTFET-Based 7T SRAM Cell for Ultra-Low Voltage Applications

2D Short‐Channel Tunneling Transistor Relying on Dual‐Gate Modulation for Integrated Circuits Application

Analysis of etched drain based Cylindrical agate‐all‐around tunnel field effect transistor based static random access memory cell design

A Novel TFET-MOSFET Hybrid SRAM for Ultra-Low-Power Applications

Vertical Surrounding Gate Transistor for High Density and Low Voltage Operation in DRAM

Design of RTD-Based TSRAM

A Novel Self-Aligned Dopant-Segregated Schottky Tunnel-FET with Asymmetry Sidewall Based on Standard CMOS Technology

Low voltage SRAM design using tunneling regime of CNTFET

Enhanced Transient Behavior in MIS(p) Tunnel Diodes by Trench Forming at the Gate Edge