Abstract:This work aims to study a possible modification in the electronic structure of scandia-ceria-stabilized zirconia (10Sc1CeSZ) ceramics sintered at different temperatures. In addition to using X-ray diffraction (XRD), scanning electron microscopy (SEM) and impedance spectroscopy to investigate the structural and electrical properties, we employed X-ray photoelectron spectroscopy (XPS) to determine the chemical state information of the atoms involved, along with compositional analysis. As expected, a significant increase in grain ionic conductivity with the sintering temperature was present. This increase was accompanied by a decrease in the porosity of the samples, an increase in the grain size, and a transformation from the rhombohedral to the cubic phase. The phase transformation was detected not only using XRD, but also using XPS and, for this type of ceramic, XPS detected this transformation for the first time. In addition to the changes in the structural characteristics, the increase in the ionic conductivity was accompanied by a modification in the electronic structure of the ceramic surface. The XPS results showed that the surface of the ceramic sintered at the lower temperature of 1100 °C had a higher amount of Zr-OH bonds than the surface of the ceramic sintered at the higher temperature of 1400 °C. The existence of these Zr-OH bonds was confirmed using Fourier-transform infrared spectroscopy (FTIR). From this result, taken together with the difference between the oxygen/zirconium ratios in these ceramics, also identified using XPS, we conclude that there were fewer oxygen vacancies in the ceramic sintered at the lower temperature. It is argued that these two factors, together with the changes in the structural characteristics, have a direct influence on the conductive properties of the studied ceramics sintered at different temperatures.

The Influence of Precipitation Temperature on the Properties of Ceria–zirconia Solid Solution Composites

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Effects of co-precipitation temperature on structure and properties of La and Y doped cerium zirconium mixed oxides

Effects of Zr on the Precursor Architecture and High-Temperature Nanostructure Evolution of Sioc Polymer-Derived Ceramics

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Influences of Oxygen Precipitation on Vickers Hardness of Czochralski Silicon

Influence of the Metal Particle Size and Sintering Process on the Electrical Resistivity of M-Zro2/30%mo Cermet

The influence of H2O2 on the properties of CeO2-ZrO2 mixed oxides

X-ray Photoelectron Spectroscopy Analysis of Scandia-Ceria-Stabilized Zirconia Composites with Different Transport Properties

Fabrication and Mechanical Properties of Homogeneous Zirconia Toughened Alumina Ceramics Via Cyclic Solution Infiltration and in Situ Precipitation

Sintering Behavior and Mechanical Properties of Alumina-Coated Zirconia Ceramics

Mechanical properties and low temperature degradation (LTD) of cation-stabilized zirconia

Synthesis of a homogeneous CeO2–ZrO2-Al2O3 composite material by a novel hydrothermal assisted precipitation method

Preparation of Porous Spodumene/zircon Composite Ceramics and Its Thermal and Mechanical Properties

Synthesis and Infrared Radiation Properties of Cordierite-Zirconia Composite Powders

Crystal Structure, Infrared Spectra, and Microwave Dielectric Properties of Ce2(Zr0.94Sn0.06)3(MoO4)9 Ceramics With Low Sintering Temperature

Effect of Si/Zr molar ratio on the sintering and crystallization behavior of zircon ceramics

Mesoporous Yttria-Zirconia Solid Solution with Improved Textural Properties Prepared Via Lauric Acid-Assisted Synthesis

Effect Of Different Ce2o3 On The Structure And Properties Of Bzt-Ct Ceramics

Study on the process and properties of nano-sized polycrystal zirconia powders by co-precipitation in super-alkaline medium

Effect of annealing temperature on the microstructure, dielectric, and microwave absorption performance of precursor blends derived ZrSiOCN ceramics