Abstract:An air-breathing micro direct methanol fuel cell (mu DMFC) with a water collecting and recycling cathode structure is presented in this paper. The mechanism of water generation in cathode and water collection from the cathode is studied. The capillary channels with hydrophilic surface are designed along the ribs of the air-breathing cathode window to collect excessive water. The collected water is then released via an exhaust pipe. Microfabrication techniques, including double-side lithography and KOH etching, are used to fabricate the anode and cathode plates of the mu DMFC on the same silicon wafer simultaneously. The silicon plate surface is treated by low temperature oxygen plasma to improve the hydrophilicity. The mu DMFC with the water collecting and recycling structure and the regular one without, both with an active area of 7.8 x 7.8 mm(2), are assembled and characterized. Experimental results show that the maximum power density and current density of the both mu DMFCs are more than 10 mW cm(-2) and nearly 100 mA cm(-2) at room temperature, respectively. After both mu DMFCs operate at 0.15 V (about 60 mA cm(-2) at room temperature) for 1 h, the outputs of the prototype with water collecting and recycling structure decrease to about 9.7 mW cm(-2) and 95 mA cm(-2) only, while that of regular one decrease to 9 mW cm(-2) and 75 mA cm(-2). The water is collected by the exhaust pipe in evidence. As such, it would be possible to recycle the water from cathode to anode. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Asymmetric Design of Anode and Cathode Current Collectors for Micro Direct Methanol Fuel Cells

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Modeling study of an air‐breathing micro direct methanol fuel cell with an extended anode catalyst region

Capillary-based Water Removal Cathode for an Air-Breathing Micro Direct Methanol Fuel Cell

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells

Experimental investigations on the effect of current collector open ratio on the performance of a passive direct methanol fuel cell with liquid electrolyte layer

Numerical simulation on mass transport in a passive vapor-fed direct methanol fuel cell operating with neat methanol

Novel Anode Electrode Structure with a Fuel Management Layer for High-Concentration Passive Direct Methanol Fuel Cells

A Liquid–Vapor Two-Phase Model of Direct Methanol Fuel Cells With Platinum Group Metal-Free Cathode Catalyst

Design and Fabrication of Fuel-Self-Propelled Reaction Device for Passive Micro Direct Methanol Fuel Cell Anodes

Preparation and Simulation of an Additional Catalyst Layer for Direct Methanol Fuel Cell

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

An Air-Breathing Micro Direct Methanol Fuel Cell Stack Employing a Single Shared Anode Using Silicon Microfabrication Technologies

Optimization of Membrane Electrode Assembly in Air-Breathing Direct Methanol Fuel Cell

Effect of Methanol Concentration on Performance of Passive DMFC

A model investigation of the performance of a novel anode flow-field structure with microblocks for micro direct methanol fuel cells

A Neat Methanol Fed Passive DMFC with a New Anode Structure

Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack