Abstract:Silicon carbon nitride thin films were deposited on Co-Cr alloy under varying deposition conditions such as sputtering power and the partial pressure ratio of N(2) to Ar by radio frequency and direct current magnetron sputtering techniques. The chemical bonding configurations, surface topography and hardness were characterized by means of X-ray photoelectron spectroscopy, atomic force microscopy and nano-indentation technique. The sputtering power exhibited important influence on the film composition, chemical bonding configurations and surface topography, the electro-negativity had primary effects on chemical bonding configurations at low sputtering power. A progressive densification of the film microstructure occurring with the carbon fraction was increased. The films prepared by RF magnetron sputtering, the relative content of the Si-N bond in the films increased with the sputtering power increased, and Si-C and Si-Si were easily detachable, and C-O, N-N and N-O on the film volatile by ion bombardment which takes place very frequently during the film formation process. With the increase of sputtering power, the films became smoother and with finer particle growth. The hardness varied between 6 GPa and 11.23 GPa depending on the partial pressure ratio of N(2) to Ar. The tribological characterization of Co-Cr alloy with Si-C-N coating sliding against UHMWPE counter-surface in fetal bovine serum, shows that the wear resistance of the Si-C-N coated Co-Cr alloy/UHMWPE sliding pair show much favourable improvement over that of uncoated Co-Cr alloy/UHMWPE sliding pair. This study is important for the development of advanced coatings with tailored mechanical and tribological properties. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.

Sputter deposited NbC x N y films: Effect of nitrogen content on structure and mechanical and tribological properties

Effects of Nitrogen Content on Microstructures and Mechanical Behavior of (titacrmonb)nx Films

Microstructure, Mechanical, and Tribological Properties of CN X Thin Films Prepared by Reactive Magnetron Sputtering

Effects of the carbon-to-nitrogen ratio on the microstructure and properties of (CrNbSiTiZr)CxNy high-entropy carbonitride films

Structural And Tribological Characteristics Of Carbon Nitride Films Deposited By The Reactive Ionized-Cluster Beam Technique

Investigation of carbon nitride films by cathodic arc evaporation

Effects of Nitrogen Flow Ratio on the Structure and Properties of Reactively Sputtered (almonbsitativzr)n(x) Coatings

Microstructure and Mechanical Properties of Carbon Nitride Multilayer Films Deposited by DC Magnetron Sputtering

Optimizing hardness of CN x thin films by dc magnetron sputtering and a statistical approach

Optical & Electronic Properties of Carbon Nitride Thin Films

Tribological Properties of Ta‐C‐N and Ta‐N Thin Films

Structure and tribological properties of carbon nitride films obtained by the reactive ionized cluster beam method

Synthesis, composition, surface roughness and mechanical properties of thin nitrogenated carbon films

Structure and properties of carbon nitride films synthesized by low energy ion bombardment

Structure, Composition and Mechanical Properties of Reactively Sputtered (tivcrtaw)nx High-Entropy Films

The Structure, Surface Topography and Mechanical Properties of Si–C–N Films Fabricated by RF and DC Magnetron Sputtering

Film Thickness Effects on Mechanical and Tribological Properties of Nitrogenated Diamond-Like Carbon Films

Effects of nitrogen content on structure and mechanical properties of multi-element (AlCrNbSiTiV)N coating

Microstructure, mechanical and tribological properties of Ti–B–C–N films prepared by reactive magnetron sputtering

Effects of C/Si ratios on structures and behaviors of NbSiCN nanocomposite films synthesized by reactive magnetron sputtering

Microstructure and Tribological Behavior of BCN Thin Films with Different Nitrogen Contents