Abstract:Dye-sensitized solar cells (DSSC) are based on the absorption of photons by dye, and the transfer of these to TiO2 electrodes. The microstructure and defects of TiO2 electrodes are vital for the fabrication of high efficiency dye-sensitized solar cells. These properties strongly relate to the TiO2 electrode method of fabrication and its parameters. In this research, the effect of drying and thickness of the nanocrystallineTiO2 electrodes were investigated. Nanocrystalline TiO2 thin films of different thicknesses were deposited on FTO-coated glass substrates using a tape casting method. Then, these electrodes were dried at different temperatures (130°C and 70°C) at different heating rate. Subsequently, the electrodes were immersed into a dye solution. After dyeing, the cells were assembled using the dye-covered TiO2 electrodes and platinum-coated FTO and iodine electrolytes. These samples were characterized by SEM, TGA, FTIR, OM and the cell performance then measured by a solar light simulator at an intensity of 1000 W.m-2. Drying the electrodes at different temperature and different heating rate showed that the solar cells with a TiO2 electrode dried at 130°C, and at lower heating rate gave a higher short-circuit current density and open circuit voltage, with a higher overall conversion efficiency of 5.1%. The effect of the thickness of TiO2 films on the parameters of DSSCs was also investigated. Results showed that by increasing the thickness of the TiO2 films, absorption of the N719 dye through the TiO2 layers increased to a more optimum level, so that power conversion efficiency (η) of 7.51 % was obtained.

Xps Study Of Aluminum Coating On Tio2 Anode Of Dye-Sensitized Solar Cells

Improved Performance of Dye Sensitized Solar Cells Using Cu-doped TiO2 As Photoanode Materials: Band Edge Movement Study by Spectroelectrochemistry

COATING EFFECT OF TiO2 PHOTOANODE FOR DYE-SENSITIZED SOLAR CELL

Alumina Post-Modification After Dye-Sensitization: Effect On The Performance Of Quasi-Solid State Solar Cells

Post-modification Using Aluminum Isopropoxide after Dye-Sensitization for Improved Performance and Stability of Quasi-Solid-state Solar Cells

A Simple and Efficient Method Using Polymer Dispersion to Prepare Controllable Nanoporous TiO2 Anodes for Dye-Sensitized Solar Cells

Enhancing the performance of dye-sensitized solar cells: doping SnO2 photoanodes with Al to simultaneously improve conduction band and electron lifetime

Post-assembly Atomic Layer Deposition of Ultrathin Metal-Oxide Coatings Enhances the Performance of an Organic Dye-Sensitized Solar Cell by Suppressing Dye Aggregation.

ZnO/Ti3C2Tx Composite Photoanodes for Efficient Dye-Sensitized Solar Cells

Efficiency Improvement in Dye-Sensitized Solar Cells by Modify Titanium Dioxide Formation on Supercritical Carbon Dioxide Fluid Synchronous Dyeing

Zinc Oxide Precursor Treatment for Improving Dye-Sensitized Solar Cell Efficiency

Performance Improvement of Dye-Sensitized Solar Cell by Optimizing TiO<sub>2</sub>-Photoanode Structure

Efficiency Boost in Dye-Sensitized Solar Cells by Post- Annealing UV-Ozone Treatment of TiO2 Mesoporous Layer

Preparation of high efficiency TiO_2 photoanode for dye-sensitized solar cells by electrostatic spray

Effect of the Addition of Ti3+ into TiO2 Film on the Performance of Dye Sensitized Solar Cells

Al2O3-coated SnO2/TiO2 Composite Electrode for the Dye-Sensitized Solar Cell

The Effect of Different Dopants on the Performance of SnO2‐based Dye‐sensitized Solar Cells

Titanium Dioxide-Coated Zinc Oxide Nanorods as an Efficient Photoelectrode in Dye-Sensitized Solar Cells

The Effect of Drying and Thickness of TiO2 Electrodes on the Photovoltaic Performance of Dye-Sensitized Solar Cells

Research on Photovoltaic Measurement and Electrochemical Impedance Spectroscopy Analysis of Dye-Sensitized Solar Cells With Modification of Photoanodes by TiO2 Nanofibers Composited With Zn2SnO4-SnO2 Under Various Illuminances

Improvement of Photovoltaic Performance of Dye-Sensitized Solar Cell by Post Heat Treatment of Polymer-Capped Nano-Platinum Counterelectrode