Abstract:High-temperature superconducting traction transformers (HTSTT) have the merits of small size and lightweight in comparison with their conventional counterparts. This article reports the development progress of a 6.6 MVA HTSTT operating at 65 K, including the design, testing, and system cooling. The introduction of flux diverters and an optimized winding design realized a short-circuit impedance higher than 43% and AC loss less than 3 kW. The insulation structure was designed to pass insulation tests specified in standard in China GB/T 25120-2010. An open cooling system with reduced pressure was developed, which realized the efficiency of the 6.6 MVA HTSTT above 99%. Before assembling the prototype transformer, we conducted tests for critical current and dielectric performance of the HTS double pancake coils (DPC) used in high-voltage (HV) and low- voltage (LV) windings to verify the current-carrying and insulation performances of each DPC. Finally, we measured the critical current and no-load loss of the HTSTT prototype at 77 K. Test results showed that the mass of the transformer is 33% less than conventional transformers. At 77 K, the critical current of the LV winding and HV winding is higher than 700 A and 50 A, respectively. Moreover, the HTSTT on a no-load test reached the test voltage of 25,000 V and loss of 6 kW. In the next step, we will continue to conduct experimental research, and verify the feasibility of the HTSTT on the train, and develop a circulating cooling system, all meeting the commercial requirements of the HTSTT.

Characteristic Tests and Electromagnetic Analysis of an HTS Partial Core Transformer

Design and Test Performance of 2g Pancake Coils for Hts Dc Induction Heater Prototype

Development of a Conduction-Cooled HTS SMES

Electromagnetic Analysis Of An Air-Core Hts Transformer

HTS Air-Core Pulse Transformer for Electromagnetic Launch

Design and Electromagnetic Analysis of Hybrid Megawatt High Temperature Superconducting Transformer

Theoretical Analysis and Experiment Research of High Temperature Superconducting Air-Core Transformer

A Single Phase Model 9 Kva High-Temperature Superconducting Power Transformer

An Optimize Design of HTS Transformer:Multi-Width and Multi-Distance Structure

Development of a Three-Phase HTS Power Transformer

Performance and Analysis of No-Insulation HTS Toroidal Magnet

Development of A 630 Kva Three-Phase Hts Transformer with Amorphous Alloy Cores

Development of a 45 Kva Single-Phase Model HTS Transformer

Electromagnetic Characteristics Analysis of Core Cable Consisting of Ybco Coated Conductor

Detection and Analysis of Fault for HTS AMDT Cores by Magnetostriction-Induced Vibration

Design, development, and testing of a 6.6 MVA HTS traction transformer for high-speed train applications

The Magnetic Properties of the Ferromagnetic Materials Used for HTS Transformers at 77 K

Over-Current Simulation Test for High Temperature Superconducting Generator

Experimental and numerical study of high frequency superconducting air-core transformer

THE FEASIBILITY RESEARCH OF THE HTS AIR-CORE PULSE TRANSFORMER

Electromagnetic Design of HTS D-shaped Coils for a Toroidal-type Superconducting Magnet