Abstract:High-temperature superconducting traction transformers (HTSTT) have the merits of small size and lightweight in comparison with their conventional counterparts. This article reports the development progress of a 6.6 MVA HTSTT operating at 65 K, including the design, testing, and system cooling. The introduction of flux diverters and an optimized winding design realized a short-circuit impedance higher than 43% and AC loss less than 3 kW. The insulation structure was designed to pass insulation tests specified in standard in China GB/T 25120-2010. An open cooling system with reduced pressure was developed, which realized the efficiency of the 6.6 MVA HTSTT above 99%. Before assembling the prototype transformer, we conducted tests for critical current and dielectric performance of the HTS double pancake coils (DPC) used in high-voltage (HV) and low- voltage (LV) windings to verify the current-carrying and insulation performances of each DPC. Finally, we measured the critical current and no-load loss of the HTSTT prototype at 77 K. Test results showed that the mass of the transformer is 33% less than conventional transformers. At 77 K, the critical current of the LV winding and HV winding is higher than 700 A and 50 A, respectively. Moreover, the HTSTT on a no-load test reached the test voltage of 25,000 V and loss of 6 kW. In the next step, we will continue to conduct experimental research, and verify the feasibility of the HTSTT on the train, and develop a circulating cooling system, all meeting the commercial requirements of the HTSTT.

Development of a Three-Phase HTS Power Transformer

Development of a Conduction-Cooled HTS SMES

Design and Testing of a Medium Frequency Transformer

Design and Electromagnetic Analysis of Hybrid Megawatt High Temperature Superconducting Transformer

Design, development, and testing of a 6.6 MVA HTS traction transformer for high-speed train applications

An Optimize Design of HTS Transformer:Multi-Width and Multi-Distance Structure

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

Development and Testing of a 300-Kvar HTS Synchronous Condenser Prototype

Development of Multi-Domain Design Tool for Medium Voltage High Frequency Power Transformers

General Design of a 300-Kvar HTS Synchronous Condenser Prototype

Design of a High-Voltage-Insulation and High-Efficiency Medium Frequency Transformer

Development of a cryogenic DC transformer using for the measurement of large current

Development of Testing Device for Critical Current Measurements for HTS/LTS

Modeling and Design of Insulation Structure for High Power Density Medium Voltage High-Frequency Transformers

Design and Test of a Novel Thermal Insulated Torque Coupling for a 15-Kw Fully HTS Synchronous Generator

Stepped-shape Field Winding Optimization of a Large Capacity HTS Aircraft Propulsion Machine

Design of Medium-Voltage High-Frequency Transformers Based on High-Thermal-Conductivity Insulation Material

Development and Application of Container-Type Low-Frequency Heating Device for Ultra-High Voltage Transformers

Design Methodology for Inductor-Integrated Litz-Wired High-Power Medium-Frequency Transformer With the Nanocrystalline Core Material for Isolated DC-Link Stage of Solid-State Transformer

Development and Testing of A 2.5 Kw Synchronous Generator with A High Temperature Superconducting Stator and Permanent Magnet Rotor

Design And Demonstration Of A Sic-Based 800-V/10-Kv 1-Mw Solid-State Transformer For Grid-Connected Photovoltaic Systems