Abstract:High-temperature superconducting traction transformers (HTSTT) have the merits of small size and lightweight in comparison with their conventional counterparts. This article reports the development progress of a 6.6 MVA HTSTT operating at 65 K, including the design, testing, and system cooling. The introduction of flux diverters and an optimized winding design realized a short-circuit impedance higher than 43% and AC loss less than 3 kW. The insulation structure was designed to pass insulation tests specified in standard in China GB/T 25120-2010. An open cooling system with reduced pressure was developed, which realized the efficiency of the 6.6 MVA HTSTT above 99%. Before assembling the prototype transformer, we conducted tests for critical current and dielectric performance of the HTS double pancake coils (DPC) used in high-voltage (HV) and low- voltage (LV) windings to verify the current-carrying and insulation performances of each DPC. Finally, we measured the critical current and no-load loss of the HTSTT prototype at 77 K. Test results showed that the mass of the transformer is 33% less than conventional transformers. At 77 K, the critical current of the LV winding and HV winding is higher than 700 A and 50 A, respectively. Moreover, the HTSTT on a no-load test reached the test voltage of 25,000 V and loss of 6 kW. In the next step, we will continue to conduct experimental research, and verify the feasibility of the HTSTT on the train, and develop a circulating cooling system, all meeting the commercial requirements of the HTSTT.

Development of A 630 Kva Three-Phase Hts Transformer with Amorphous Alloy Cores

Development of a Three-Phase HTS Power Transformer

Development of a 45 Kva Single-Phase Model HTS Transformer

A Single Phase Model 9 Kva High-Temperature Superconducting Power Transformer

Development of a Conduction-Cooled HTS SMES

Design and Electromagnetic Analysis of Hybrid Megawatt High Temperature Superconducting Transformer

The Magnetic Properties of the Ferromagnetic Materials Used for HTS Transformers at 77 K

Design, development, and testing of a 6.6 MVA HTS traction transformer for high-speed train applications

An Optimize Design of HTS Transformer:Multi-Width and Multi-Distance Structure

Stability Of Properties On Magnetic Ribbon And Cores With Domestic Fe-Based Amorphous Alloy For Hts Amdt

Design of the Cryogenic System for a 400 Kw Experimental HTS Synchronous Motor

Theoretical Analysis and Experiment Research of High Temperature Superconducting Air-Core Transformer

The Development of 4 M HTS Power Cable

High-voltage High-Frequency Transformer Design for a 7.2kv to 120V/240V 20kva Solid State Transformer

Thermal Analysis for the Hts Stator Consisting of Hts Armature Windings and an Iron Core for A 2.5 Kw Hts Generator

A High Power 200kW Medium Frequency Transformer With Improved Thermal Management

General Design of a 300-Kvar HTS Synchronous Condenser Prototype

A Novel High Insulation 100 Kw Medium Frequency Transformer

Design and Test of a Novel Thermal Insulated Torque Coupling for a 15-Kw Fully HTS Synchronous Generator

Development and Testing of A 2.5 Kw Synchronous Generator with A High Temperature Superconducting Stator and Permanent Magnet Rotor

Design of a 30-K/4-kj HTS Magnet Cryocooled with Solid Nitrogen