Abstract:Now 1000-kV ac ultra-high voltage transmission line has been put into operation in China, the transmission tower reaches about 70 m to 90 m high, and 30 m to 60 m wide. So, the 1000-kV transmission line has a wide lightning induced area. On the other hand, the operation voltage is very high, all these increase the probability of lightning striking UHV transmission lines. Due to insulation level of the 1000-kV transmission line is very high, so the threaten of direct lightning stroke is very small, but the high towers increase the shielding failure probability. In this paper, we proposed a numerical model to analyze the shielding failure characteristics of 1000- kV ac transmission line with the lightning leader propagation process considered, the electrical field of the system including lightning leader, transmission line and ground is solved. According to analysis results, we found if the span between two overhead ground wires of transmission line is too wide, a new phenomenon of middle-phase shielding failure takes place, the downward lightning leader of current magnitude higher than 100 kA would strike the middle phase conductor bypassing the ground wires. The middle-phase shielding failure is caused by the very high operation voltage of 1000-kV ultra-high voltage transmission line and wide designed span between two ground wires. The mechanism to generate this phenomenon is different from that of small lightning current, and the EGM can not properly explain this phenomenon. For the cat-head tower, the high shielding failure probability is caused by the middle-phase shielding failure, but for the cup tower, the shielding failure mainly takes place on the side phases. At last, the related measures to improve the lightning performances of 1000-kV ultra-high voltage transmission line are discussed. Three ground wires had been applied in the 2 km section of 1000-kV Jindongnan-Nayang transmission-line near the 1000-kV substation.

Lightning shielding protection design and actualization of 1000-kV UHVAC overhead transmission line in China

Simulated Calculation and Analysis of Lightning Performance of UHV A.C. Transmission Line

Lightning shielding failure analysis of 1000-kV ultra-high voltage ac transmission line

Analysing on Characteristics of Lightning Shielding Failure of UHVAC Double Circuit Transmission Line Based on Leader Progression Method

Lightning Withstand Performance of the Yun-guang ±800kv UHVDC Power Transmission Line

On the 110kV High Voltage Transmission Line Lightning Protection

Lightning Performance of Quadruple-circuit Transmission Line with Dual Voltage 500/220 Kv on the Same Tower

Approaching to Rotated Lightning Strike on Transmission Line

Calculation of Surface Electric Field on Uhv Transmission Lines under Lightning Stroke

Comparative Research on Z-Type Tower and Traditional T-Type Tower for UHVDC Transmission Lines Located at Mountain Areas

Lightning strike characteristics of +/- 800-kV DC UHV transmission lines

Lightning Protection Technology of 110kv-220kv High-voltage Transmission Line

The Lightning Protection Characteristics of ±800 kV Yunnan – Guangdong UHVDC Transmission Line

Improved Electrogeometric Model of UHV Transmission Line Based on Long Gap Discharge and Its Application

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

Analysis On Lightning Current And Position During Shielding Failure Of High Voltage Ac Transmission Lines

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Study on the Calculation of Shielding Failure for Dc Transmission Lines

Electromagnetic model of lightning shielding failure of transmission line

Study on the lightning shielding characteristics of the crossover area of UHV/HV transmission lines

Lightning Shielding Failure Characteristics of UHVDC Transmission Line Using Leader Progress Method