Abstract:Now 1000-kV ac ultra-high voltage transmission line has been put into operation in China, the transmission tower reaches about 70 m to 90 m high, and 30 m to 60 m wide. So, the 1000-kV transmission line has a wide lightning induced area. On the other hand, the operation voltage is very high, all these increase the probability of lightning striking UHV transmission lines. Due to insulation level of the 1000-kV transmission line is very high, so the threaten of direct lightning stroke is very small, but the high towers increase the shielding failure probability. In this paper, we proposed a numerical model to analyze the shielding failure characteristics of 1000- kV ac transmission line with the lightning leader propagation process considered, the electrical field of the system including lightning leader, transmission line and ground is solved. According to analysis results, we found if the span between two overhead ground wires of transmission line is too wide, a new phenomenon of middle-phase shielding failure takes place, the downward lightning leader of current magnitude higher than 100 kA would strike the middle phase conductor bypassing the ground wires. The middle-phase shielding failure is caused by the very high operation voltage of 1000-kV ultra-high voltage transmission line and wide designed span between two ground wires. The mechanism to generate this phenomenon is different from that of small lightning current, and the EGM can not properly explain this phenomenon. For the cat-head tower, the high shielding failure probability is caused by the middle-phase shielding failure, but for the cup tower, the shielding failure mainly takes place on the side phases. At last, the related measures to improve the lightning performances of 1000-kV ultra-high voltage transmission line are discussed. Three ground wires had been applied in the 2 km section of 1000-kV Jindongnan-Nayang transmission-line near the 1000-kV substation.

Electromagnetic model of lightning shielding failure of transmission line

Numeral Analysis Model for Shielding Failure of Transmission Line under Lightning Stroke

Approaching to Rotated Lightning Strike on Transmission Line

Comparison of Numerical Analysis Models for Shielding Failure of Transmission Lines

Analysis On Lightning Current And Position During Shielding Failure Of High Voltage Ac Transmission Lines

Analysis of Shielding Failure Parameters of High Voltage Direct Current Transmission Lines

Analysis on shielding failure of large lightning current of transmision lines

Lightning Shielding Failure Model of Transmission Line Ased on Leader Progress Model

Calculation of Surface Electric Field on Uhv Transmission Lines under Lightning Stroke

Analysis of AC and DC Flat Transmission Lines Lightning Shielding Failure

Lightning shielding failure analysis of 1000-kV ultra-high voltage ac transmission line

Analysis On Shielding Fallure Of Large Lightning Current Of Transmision Lines

Study on the Calculation of Shielding Failure for Dc Transmission Lines

Simulated Calculation and Analysis of Lightning Performance of UHV A.C. Transmission Line

Analysis of Significant Parameters Affecting the Shielding Failure of HVDC-TL.

Lightning Performance of Quadruple-circuit Transmission Line with Dual Voltage 500/220 Kv on the Same Tower

Calculation of Shielding Failure Flashover Rate of Transmission Line Using Leader Progression Model

Lightning Protection Study of Transmission Line,Part Ⅱ:Analysis Methods

Research on characteristics of surface electric field on transmission lines under lightning stroke

Fractal Model of Lightning Channel for Simulating Lightning Strikes to Transmission Lines

Analysing on Characteristics of Lightning Shielding Failure of UHVAC Double Circuit Transmission Line Based on Leader Progression Method