Abstract:A radio-frequency micro-electro-mechanical system (RF MEMS) wafer-level packaging (WLP) method using pre-patterned benzo-cyclo-butene (BCB) polymers with a high-resistivity silicon cap is proposed to achieve high bonding quality and excellent RF performance. In this process, the BCB polymer was pre-defined to form the sealing ring and bonding layer by the spin-coating and patterning of photosensitive BCB before the cavity formation. During anisotropic wet etching of the silicon wafer to generate the housing cavity, the BCB sealing ring was protected by a sputtered Cr/Au (chromium/gold) layer. The average measured thickness of the BCB layer was 5.9 mu m. In contrast to the conventional methods of spin-coating BCB after fabricating cavities, the pre-patterned BCB method presented BCB bonding layers with better quality on severe topography surfaces in terms of increased uniformity of thickness and better surface flatness. The observation of the bonded layer showed that no void or gap formed on the protruding coplanar waveguide (CPW) lines. A shear strength test was experimentally implemented as a function of the BCB widths in the range of 100-400 mu m. The average shear strength of the packaged device was higher than 21.58 MPa. A RF MEMS switch was successfully packaged using this process with a negligible impact on the microwave characteristics and a significant improvement in the lifetime from below 10 million to over 1 billion. The measured insertion loss of the packaged RF MEMS switch was 0.779 dB and the insertion loss deterioration caused by the package structure was less than 0.2 dB at 30 GHz.

Bulk-Si with Poly Bump Process Scheme for MEMS Sensors

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

12 inch MEMS process for sensors implementation and integration

Design and implementation of an extremely large proof-mass CMOS-MEMS capacitive tilt sensor for sensitivity and resolution improvement

Processing chip for thin film bulk acoustic resonator mass sensor

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Molding/Encapsulation/Integration Approach for Tactile-Bump And Sensing-Interface of Inductive Tactile Sensor

Pick-and-place process for sensitivity improvement of the capacitive type CMOS MEMS 2-axis tilt sensor

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

Monolithic Integration of Capacitive Sensors Using A Double-Side Cmos Mems Post Process

Fabrication of High‐Density Micro‐Bump Arrays for 3D Integration of MEMS and CMOS

Micromachining of Multi-Thickness Sensor-Array Structures with Dual-Stage Etching Technology

High density and through wafer copper interconnections and solder bumps for MEMS wafer-level packaging

High performance MEMS tactile sensor array with robustness and fabrication simplicity

Monolithic Mems Soc Design And Fabrication Using 0.35 Mu M Bcd Technology

Wafer-Level Self-Packaging Design and Fabrication of MEMS Capacitive Pressure Sensors

Post-Cmos Selective Electroplating Technique for the Improvement of Cmos-Mems Accelerometers

Integration of PDMS-infiltrated CNTs and Si bulk-micromachining for monolithic physical sensors application

Wafer-Level Packaging Method For Rf Mems Applications Using Pre-Patterned Bcb Polymer

A New Symmetrical Beam-Mass Structure for Accelerometers by Anisotropic Etching Without Convex Corner Compensation