Abstract:This paper presents a low jitter All-Digital Delay-Locked Loop (ADDLL) with fast lock time and process immunity. A coarse locking algorithm is proposed to prevent harmonic locking with just a small increase in hardware resources. In order to effectively solve the dithering phenomenon after locking, a replica delay line and a modified binary search algorithm with two modes were introduced in our ADDLL, which can significantly reduce the peak-to-peak jitter of the replica delay line. In addition, digital codes for a replica delay line can be conveniently applied to the delay line of multi-channel Vernier TDC while maintaining consistency between channels. The proposed ADDLL has been designed in 55 nm CMOS technology. In addition, the post-layout simulation results show that when operated at 1.2 V, the proposed ADDLL locks within 37 cycles and has a closed-loop characteristic, the peak-to-peak and root-mean-square jitter at 800 MHz are 6.5 ps and 1.18 ps, respectively. The active area is 0.024 mm2 and the power consumption at 800 MHz is 6.92 mW. In order to verify the performance of the proposed ADDLL, an architecture of dual ADDLL is applied to Vernier TDC to stabilize the Vernier delay lines against the process, voltage, and temperature (PVT) variations. With a 600 MHz operating frequency, the TDC achieves a 10.7 ps resolution, and the proposed ADDLL can keep the resolution stable even if PVT varies.

A Background Jitter Optimization Method for Pll Based on Time-To-Digital Converter

Modeling of digital background calibration with signal-dependent dithering for a 14-bit, 100-MS/s pipelined ADC

A Maximum-Likelihood-Estimation-Based Digital Background Calibration Technique for Interstage Gain Error in Pipelined ADCs

A Delay Matching Technique for Relative Deterministic Jitter Reduction in 28ghz ADPLL

A Clock Calibration Method for an All-Digital Burst-Mode CDR with Embedded TDC

Digital Background Calibration for Timing Skew in Time-Interleaved ADC.

A Dithered-Digital-Mixing Background Timing-Skew Calibration Method for Time-Interleaved ADCs

A Dual-Loop Injection-Locked PLL with All-Digital Background Calibration System for On-Chip Clock Generation

A Low-Jitter Harmonic-Free All-Digital Delay-Locked Loop for Multi-Channel Vernier TDC

Jitter Measurement Method for Multi-level Disc Based on Interpolation Algorithm

A 0.8-Ps RMS Precision Period Jitter Measurement Circuit with Offset Reduction

Lms-Fir Based Digital Background Calibration For The Four-Channel Time-Interleaved Adc

An improved wide-range, low-complexity, fully-parallel digital background timing mismatch calibration method for dual-channel TIADC based on perfect reconstruction filter bank

Low-Power Built-in Jitter Injection Using Linearized Phase Interpolator

A Low Jitter Current-Mode Multiplying Delay-Locked Loop Applied to High-Precision TDC

Design Of Low Jitter Adaptive-Bandwidth Charge Pump Pll With Passive Filter

A Jitter Programmable Digital Bang-Bang PLL Using PVT-Invariant Stochastic Jitter Monitor

A PLL/DLL Based CDR with ΔΣ Frequency Tracking and Low Algorithmic Jitter Generation

A Digital-Background TIADC Calibration Architecture and a Fast Calibration Algorithm for Timing-Error Mismatch

Jitter Generation Model Based on Timing Modulation and Cross Point Calibration for Jitter Decomposition

Jitter Measurement Method for Multi-Level Disc Based on Quadratic Interpolation Algorithm