Abstract:For the measurement of text high-speed communication signals, whether it is to check the signal's bit error rate (BER) with a BER tester or to record the signal's eye diagram with an equivalent-time oscilloscope, a clock and data recovery (CDR) circuit is required to generate a trigger signal properly aligned to the input data signal. For the system under test, where multiple communication protocols coexist, a wide operation frequency range and low-jitter CDR circuit can undoubtedly improve the measurement efficiency and reduce the cost. However, obtaining broad frequency coverage and minimal recovery clock jitter simultaneously has always been a challenge in the design of CDR circuits. This article proposes a CDR circuit combining a multiband LC-voltage-controlled oscillator (VCO) and a configurable frequency divider, which effectively expands the operating frequency range of the CDR while maintaining the low jitter of the recovered clock. A 0.2–7.1-Gb/s CDR circuits with a 1.9-ps rms jitter of the recovered clock under a 7.1-Gb/s input pseudorandom binary sequence (PRBS) signal is implemented in 65-nm CMOS. Compared with other LC-VCO-based CDRs, the proposed CDR achieves better energy efficiency and lower jitter performance.

Low-Power Built-in Jitter Injection Using Linearized Phase Interpolator

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

A High-Linearity 14ghz 7b Phase Interpolator for Ultra-High-Speed Wireline Applications

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

Photonic Phase-Stabled Transmission of Broadband Signals Based on Passive Compensation

A PLL/DLL Based CDR with ΔΣ Frequency Tracking and Low Algorithmic Jitter Generation

An Ultra Low Power Integer-N PLL with a High-Gain Sampling Phase Detector for IOT Applications in 65 nm CMOS

A Low Jitter 2.125ghz Serial Link for Optical Transmission

A 0.4-Ps-jitter −52-Dbc-spur Synthesizable Injection-Locked PLL with Self-Clocked Nonoverlap Update and Slope-Balanced Subsampling BBPD

A Compact, Low-Power and Low-Jitter Dual-Loop Injection Locked PLL Using All-Digital PVT Calibration

A 40-Gb/s Low-Power Wire Line Transceiver Architecture with Multi-Phase Injection-Locked Clocking Scheme

A 10ghz Analogphase Interpolator Based on a Novel Quadrature Clock Generator

Low Jitter and Low Power PLL : Towards the Utopia

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A low-jitter frequency synthesizer with dynamic phase interpolation for high-speed Ethernet.

A Dual-Loop Injection-Locked PLL with All-Digital Background Calibration System for On-Chip Clock Generation

An improved 40 Gb/s CDR with jitter-suppression filters and phase-compensating interpolators

Theoretical Modeling and Simulation of Phase-Locked Loop (PLL) for Clock Data Recovery (CDR)

High Performance Injection-Locked PLL Architectures: An Overview

A Low Jitter, Low Spur Multiphase Phase-Locked Loop for an Ir-Uwb Receiver