Abstract:The rapid development of the next-generation high-speed wireless communication system has set increasingly stringent requirements on the spectral purity of local RF oscillators. Low phase noise is crucial to support advanced modulation scheme enabling high data-rates wireless link [1]. A viable popular approach is to coupled N identical oscillators together to improve the phase noise by 10log <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">10</inf> N at the cost of N times higher power [2]–[6]. Nevertheless, the coupling network needs to be designed carefully to avoid undesired multi-tone concurrent oscillations. Besides, area occupation is another issue of multi-core VCOs. The star-geometry as shown in Fig. 1. (bottom left), which is simple N times duplication of single core, occupies N times larger area so comes with an area penalty [3]–[5]. To solve this problem, circular geometry is proposed where the passives are merged into a single passive structure and the minimal realizable inductance is reduced while keeping a high Q factor [6]–[7]. In order to further reduce the silicon area, a square-geometry quad-core oscillator with inductor sharing technique is proposed in this paper and it exhibits a compact area of 0.09 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> , which is the smallest quad-core VCO operating at a similar oscillation frequency. The unwanted mode is suppressed by the metal trace that connects the drain node of adjacent cores. Thanks to the proposed square-geometry and inductor sharing technique, the proposed quad-core class-F VCO can further reduce the area occupation. The proposed VCO is fabricated in 65nm CMOS technology. The measured phase noise is -137.2 dB/Hz at 10 MHz offset frequency from a carrier of 19 GHz, which translates to the FoM of 186.1 dBc/Hz.

A 10ghz Analogphase Interpolator Based on a Novel Quadrature Clock Generator

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

A 2.4 mW 2.5 GHz multi-phase clock generator with duty cycle imbalance correction in 0.13 µm CMOS

An 8–12ghz 0.92° Phase Error Quadrature Clock Generator Based on Two-Stage Poly Phase Filter with Intermediate Point Compensation

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

A High-Linearity 14ghz 7b Phase Interpolator for Ultra-High-Speed Wireline Applications

A 5-Bit Phase-Interpolator-Based Fractional-N Frequency Divider For Digital Phase-Locked Loops

A 0.3–4.2-Ghz Frequency-Agile Phase Shifter Based on N-Path Passive Mixers Achieving Low Rms Phase/Amplitude Error

An 8.52–11.34 GHz 0.34° Phase Error Quadrature Clock Generator with Time-Voltage-Time Convertor

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

A Multiphase Clock Generation Based On Dll For Source Synchronous Receiver In 65nm Cmos Technology

A 9-Bit Vector-Sum Digital Phase Shifter Using High Resolution VGAs and Compensated Quadrature Signal Generator

Design and Realization of a Clock Phase Interpolator Circuit Based on PLL

A High-Resolution Clock Phase-Shifter in a 65 nm CMOS Technology

A 500 kHz to 150 MHz Multi-Output Clock Generator Using Analog PLL and Open-Loop Fractional Divider with 0.13 μm CMOS

A Low-Power Calibration-Free Fractional-N Digital Pll with High Linear Phase Interpolator