Abstract:Time synchronization is very important in a distributed chained seismic acquisition system with a large number of data acquisition nodes (DANs). The time synchronization error has two causes. On the one hand, there is a large accumulated propagation delay when commands propagate from the analysis and control system to multiple distant DANs, which makes it impossible for different DANs to receive the same command synchronously. Unfortunately, the propagation delay of commands (PDCs) varies in different application environments. On the other hand, the phase jitter of both the master clock and the clock recovery phase-locked loop, which is designed to extract the timing signal, may also cause the time synchronization error. In this paper, in order to achieve accurate time synchronization, a novel calibration method is proposed which can align the PDCs of all of the DANs in real time and overcome the time synchronization error caused by the phase jitter. Firstly, we give a quantitative analysis of the time synchronization error caused by both the PDCs and the phase jitter. Secondly, we propose a back and forth model (BFM) and a transmission delay measurement method (TDMM) to overcome these difficulties. Furthermore, the BFM is designed as the hardware configuration to measure the PDCs and calibrate the time synchronization error. The TDMM is used to measure the PDCs accurately. Thirdly, in order to overcome the time synchronization error caused by the phase jitter, a compression and mapping algorithm (CMA) is presented. Finally, based on the proposed BFM, TDMM and CMA, a united calibration algorithm is developed to overcome the time synchronization error caused by both the PDCs and the phase jitter. The simulation experiment results show the effectiveness of the calibration method proposed in this paper.

A Clock Calibration Method for an All-Digital Burst-Mode CDR with Embedded TDC

A Reference-Less All-Digital Burst-Mode CDR with Embedded TDC.

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

An Improved Clock Cycle Measurement Method for High-Speed Serial Signal with Duty-Cycle-Distortion Jitter

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Background Jitter Optimization Method for Pll Based on Time-To-Digital Converter

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A Half Rate CDR with DCD Cleaning Up and Quadrature Clock Calibration for 20gbps 60ghz Communication in 65nm CMOS.

A 28gbps Reference-less VCO Based CDR with Separate Proportional Path Technology in 65nm CMOS

A 19 ps Precision and 170 M Samples/s Time-to-Digital Converter Implemented in FPGA with Online Calibration

Calibration Method of the Time Synchronization Error of Many Data Acquisition Nodes in the Chained System

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

A high precision TDC based on a multi-phase clock

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

A 4–20-Gb/s 1.87-pJ/b Continuous-Rate Digital CDR Circuit With Unlimited Frequency Acquisition Capability in 65-nm CMOS

A Quadrature Clock Generator with Calibration for 22&#x223c;31.4 GS/s Real-Time Sampling System