Abstract:In the framework of fully vertical GaN-on-Silicon device technology development, we report on the optimization of non-alloyed ohmic contacts on the N-polar n+-doped GaN face backside layer. This evaluation is made possible by using patterned TLMs (Transmission Line Model) through direct laser writing lithography after locally removing the substrate and buffer layers in order to access the n+-doped backside layer. As deposited non-alloyed metal stack on top of N-polar orientation GaN layer after buffer layers removal results in poor ohmic contact quality. To significantly reduce the related specific contact resistance, an HCl treatment is applied prior to metallization under various time and temperature conditions. A 3 min HCl treatment at 70 °C is found to be the optimum condition to achieve thermally stable high ohmic contact quality. To further understand the impact of the wet treatment, SEM (Scanning Electron Microscopy) and XPS (X-ray Photoelectron Spectroscopy) analyses were performed. XPS revealed a decrease in Ga-O concentration after applying the treatment, reflecting the higher oxidation susceptibility of the N-polar face compared to the Ga-polar face, which was used as a reference. SEM images of the treated samples show the formation of pyramids on the N-face after HCl treatment, suggesting specific wet etching planes of the GaN crystal from the N-face. The size of the pyramids is time-dependent; thus, increasing the treatment duration results in larger pyramids, which explains the degradation of ohmic contact quality after prolonged high-temperature HCl treatment.

Effects of Surface Pretreatments on P-Gan/gzo Contact by Rf Magnetron Sputter

Effects of Surface Treatment on Non-alloyed Ti/Al Ohmic Contact of n-GaN

Effects of Surface Chemical Treatment and Annealing on P-Gan/zno: Ga Contact

Investigation of Ohmic Contact to Plasma-Etched N-Al0.5ga0.5n by Surface Treatment

Effect of Surface Treatment on P-Gan Ohmic Contact Property

The Effect of Wet Chemical Etching by KOH Solution to the Contact on the Solar-Blind Al 0.65 Ga 0.35 N Material

Effects of UV/O3 and O2 plasma surface treatments on the band-bending of ultrathin ALD-Al2O3 coated Ga-polar GaN

Optical and Electrical Properties of the Different Magnetron Sputter Power 300°C Deposited -ZnO Thin Films and Applications in p-i-n -Si:H Thin-Film Solar Cells

Influence and Mechanism of Surface Treatment on Ohmic Contacts to AlGaN Surface

Effects of ozone post deposition treatment on interfacial and electrical characteristics of atomic-layer-deposited Al2O3 and HfO2 films on GaSb substrates

Effect of Surface Treatments on Schottky Contact on N-Alxga1−xn/gan Heterostructures

Pulsed N2 Plasma Surface Treatment for AlGaN/GaN HEMTs Prior to PECVD SiNx Passivation to Reduce Plasma Damage

Effect of Surface Treatment on Electrical Properties of GaN Metal–insulator–semiconductor Devices with Al2O3 Gate Dielectric

Influences of the RF power ratio on the optical and electrical properties of GZO thin films by DC coupled RF magnetron sputtering at room temperature

Effects of Oxygen Plasma Etching and Post-Annealing on Pt Schottky Contact on Mg-Doped Inzno

Quantitative Study on the Effect of Surface Treatments on the Electric Characteristics of ZnO Nanowires

Effects of Oxygen Plasma Treatment on the Surface Properties of Ga-doped ZnO Thin Films

Impact of NaOH solution surface treatment on Al2O3/β-Ga2O3 MOS capacitors

Surface morphology of ZnO buffer layer and its effects on the growth of GaN films on Si substrates by magnetron sputtering

Optimization of Non-Alloyed Backside Ohmic Contacts to N-Face GaN for Fully Vertical GaN-on-Silicon-Based Power Devices

Effect of Oxygen Plasma Treatment on AlGaN Schottky Contacts