Abstract:Tungsten and its alloys have a high atomic number, high melting temperature, and high thermal conductivity, which make them fairly appropriate for use in nuclear applications in an extremely harsh radioactive environment. In recent years, there has been growing research interest in using additive manufacturing techniques to produce tungsten components with complex structures. However, the critical bottleneck for tungsten engineering manufacturing is the high melting temperature and high ductile-to-brittle transition temperature. In this study, laser powder bed fusion has been studied to produce bulk pure tungsten. And finite element analysis was used to simulate the temperature and stress field during laser irradiation. The as-printed surface as well as transverse sections were observed by optical microscopy and scanning electron microscopy to quantitatively study processing defects. The simulated temperature field suggests small-sized powder is beneficial for homogenous melting and provides guidelines for the selection of laser energy density. The experimental results show that ultra-dense tungsten bulk has been successfully obtained within a volumetric energy density of 200-391 J/mm3. The obtained relative density can be as high as 99.98%. By quantitative analysis of the pores and surface cracks, the relationships of cracks and pores with laser volumetric energy density have been phenomenologically established. The results are beneficial for controlling defects and surface quality in future engineering applications of tungsten components by additive manufacturing.

Experiment Study on the Hot-Shock Consolidation of Tungsten Powder

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Thermal Shock Performance of CVD Tungsten Coating at Elevated Temperatures

Mechanical Properties and Thermal Shock Performance of W-Y2O3composite Prepared by High-Energy-rate Forging

Development of Tungsten-Based Materials by Different Sintering Techniques

Chemical Synthesis and Oxide Dispersion Properties of Strengthened Tungsten Via Spark Plasma Sintering

Study on the Nanocrystalline Wc-10co Hard Alloys Prepared by Mixing and Explosive Compaction

Tungsten Combustion in Impact Initiated W–Al Composite Based on W(Al) Super-Saturated Solid Solution

Microstructure and Properties of Submicron-Scale TiC Particle Reinforced Titanium Matrix Composites Prepared by Shock Wave Consolidation

High-gravity Combustion Synthesis and in Situ Melt Infiltration: A New Method for Preparing Cemented Carbides

Study of a New Method to Fabricate W–Cu Composites

Preparation of Nanocrystalline Tungsten Powder and Study of Its Sinterability

Activation Pretreatment of W-1.5wt％TiC Composite Powder and Its Sintering Behavior

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

Preparation and Characteristics of W–1 Wt.% TiC Alloy Via a Novel Chemical Method and Spark Plasma Sintering

Shock compression of cemented tungsten carbides to 100 GPa: Structure of shock waves, Hugoniot relations, and strength

Study on activated W powders by chemical activation pretreatment and its sintering behavior

Explosive compact-coating of tungsten–copper alloy to a copper surface

Research on Densification of Tungsten-Copper Powders by Sintering and Hot Hydrostatic Extrusion

SPS Sintering & Joining Based on Preparation of Tungsten-Molybdenum Composite Target