Abstract:We conducted a study to investigate the impact of the laser direct metal deposition (LMD) process on the microstructure, mechanical properties, temperature fields, and stress fields of 24CrNiMo steel in order to determine the optimal process parameters. The optimal parameters were determined to be a laser power of 1400 W, scanning speed of 7 mm/s, and powder feed rate of 8 g/min. When these optimal parameters were used, the formed specimens exhibited a high densely of up to 97.5 %. The microstructure of the specimens formed different parameters primarily consisted of bainite, martensite and ferrite. The specimens formed under various process conditions demonstrated good toughness, with a maximum tensile strength of 1131±20 MPa and an elongation of 16±1.8 %. Additionally, there was little difference in wear resistance and wear morphology among the specimens formed under different processes. The predominant wear mechanisms include abrasive wear, adhesive wearand oxidative wear. Increasing laser power and decreasing scanning speed resulted in a gradual increase in the temperature gradient gradually, leading to higher residual stresses in the formed specimens. Longitudinal stresses concentrated on both sides of the deposited layer, while the transverse stresses concentrated on one side of the deposited layer. The simulation results of the temperature field and stress field were consistent with the experimental results, with errors within the range of 10 %–20 %. This study demonstrated that the simulated models of temperature and stress fields effectively captured the fundamental phenomena in the LMD process, providing valuable tools for predicting and optimizing temperature distribution and stress in the LMD process. These findings contribute to the understanding and enhancement of the LMD process for 24CrNiMo steel, making it applicable for various applications requiring superior microstructure and mechanical properties.

Influence of Process Parameters on Self-Healing Ability in Laser Metal Direct Forming

Research on the Forming Process of Three-Dimensional Metal Parts Fabricated by Laser Direct Metal Forming

Laser Direct Forming of Metal Components: Technical Characterizations

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Influence of Laser Different Waveform on Accuracy of Metal Direct Forming

The Influences of Processing Parameters on Forming Characterizations During Laser Rapid Forming

Experimental Characterization and Strengthening Mechanism of Process-Structure-property of Selective Laser Melted 316 L

Self-Regulation-Effect in Laser Direct Metal Manufacturing

Simulation and experimental studies on process parameters, microstructure and mechanical properties of selective laser melting of stainless steel 316L

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Research on process optimization and microstructure of CrCoNi medium-entropy alloy formed by laser metal deposition

Process optimization of micro selective laser melting and comparison of different laser diameter for forming different powder

Investigation on Forming Process and Product Properties of Laser Wire-Feed Additive Manufacturing for High-Quality Metal Thin-Walled Parts

Microstructure and Mechanical Property Characterizations of Metal Foil after Microscale Laser Dynamic Forming

Influence of Laser Waveform Features on Accuracy of Direct Metal Forming

Effect of laser direct metal deposition process on the microstructure and mechanical properties and temperature and stress fields of 24CrNiMo

Experimental and numerical investigation on laser beam forming of steel sheets

Study on performance optimization of 316L stainless steel parts by High-Efficiency Selective Laser Melting

Effect of Process Parameters on the Hardness of Laser Surface Textured 5A06 Aluminum Alloy

Study on Carrier Gas Flow Rate on Forming Quality of Thin Wall Parts in Laser Metal Direct Manufacturing

The Process Research of 316L Stainless Steel in Selective Laser Melting