Abstract:The first-generation semiconductor materials represented by silicon (Si) and germanium (Ge) still hold a dominant position in many fields, including micro-electromechanical systems (MEMS) and integrated circuits (ICs). The processing of these materials continues to attract significant research attention for improvements in quality and efficiency. This study proposes a novel hybrid laser-enhanced particle-laden electrochemical machining (LEPL-ECM) process, whereby pulsed laser irradiation is utilized to selectively and locally enhance the electrical conductivity of Ge at specific locations. A neutral electrolyte jet, containing abrasive diamond particles, is applied to the location on the wafer surface opposite the laser irradiation, facilitating a localized and enhanced electrochemical dissolution. The effect of micro-particle erosion effectively removes the generated oxides and potential passivation layers, ensuring continuous and efficient electrochemical reactions. Consequently, high-quality micro-dimples with an entrance diameter of about 380-800 μm, a depth of around 138-300 μm, and a quasi-mirror surface with the roughness (Sa) of as low as 59.8 nm can be achieved within 90 seconds. Furthermore, the effects of the applied voltage, laser power and processing time on the resulting dimple characteristics and surface quality are discussed, along with a detailed morphology characterization. Dense micro-pits, radial streamlined micro-grooves and a special transitional region have been observed on dimple center, sidewall and near the edge, respectively, and the formation mechanism have been analyzed. Finally, a simulation of the electrolyte jet induced fluid pressure and velocity as well as the particle trajectory and distributions within and surrounding the dimple structure was conducted, which reveals that the synergistic mechanism associated with the hybrid material removal process involves both electrochemical corrosion and abrasive erosion.

Mechanical Seal Face Texturing by the Acousto-Optic Q-Switched Pulsed Nd:Yag Laser

Investigations in the fabrication of surface patterns for wettability modification on a Zr-based bulk metallic glass by nanosecond laser surface texturing

Femtosecond Laser Micromachining of the Mask for Acoustofluidic Device Preparation

Surface Texturing with Laser Multiple-Spot Scanning Technology

Experimental study of two-phase mechanical face Seals with laser surface texturing

INTEGRATED TECHNOLOGY FOR DETECTION AND REPAIR OF MECHANICAL COMPONENT SURFACE FATIGUE MICROCRACKS USING PULSED LASER

Experimental investigation of the effect of typical surface texture patterns on mechanical seal performance

Semi Salix Leaf Textured Gas Mechanical Face Seal with Enhanced Opening Performance

Sealing performance and optimization design of squamous textured mechanical seal

Micro-dimple Surface Texture Picosecond Laser Processing and Tribological Properties

Investigation on Laser Etch-Machining Underwater Based on Thermal-Mechanical Effect

Analytical and Experimental Investigation of Laser-Textured Mechanical Seal Faces

Influence of typical technological parameters on the processing quality of laser surface texturing technology for finger sealing

High speed and low roughness micromachining of silicon carbide by plasma etching aided femtosecond laser processing

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Investigation on femtosecond laser combined with dynamic wet etching machining of SiC/SiC

Suction effect of cavitation in the reverse-spiral-grooved mechanical face seals

Improving hydrophobicity of laser textured SiC surface with micro-square convexes

Microstructure evolution and ablation mechanism of SiCf/SiC ceramic matrix composite microgrooves processed by pico-second laser

Fabrication of Interference Textures on Cemented Carbides Using Nanosecond and Femtosecond Laser Pulses

Mechanisms and characterization of a novel hybrid laser-enhanced particle laden electrochemical fabrication process for high quality micro-dimples on germanium wafers