Abstract:In recent years, to achieve favorable tribological characteristics, surface texture technology for friction reduction has been extensively studied, and its effectiveness has been successfully validated. The quality of surface texture processing directly impacts the tribological performance of finger seal friction pairs. To investigate the influence of the laser process parameters on the finger seal surface texture of the GH4169 and improve its processability and process predictability, a comparative experiment and analysis involving multiple processing parameters, including the laser power (P), laser frequency (F), scanning speed (V), and scanning times (N), were conducted. To evaluate the quality of laser surface texturing processing technology, four processing morphology parameters were established. Uniform experiments and regression analysis were employed to analyze the influence and synergistic effects of laser processing parameters on processing quality. The research results indicate that laser power, scanning times, and scanning speed are the main process parameters that significantly affect laser surface deformation. The outer diameter is directly proportional to the laser power and inversely proportional to the scanning speed; the bottom diameter ratio is directly proportional to both the laser power and scanning times; and the pit depth initially increases and then decreases with increasing laser power and scanning times. The suitable range of processing parameters is as follows: laser power (10~20%), speed range (400~700 mm/s), scanning times (8~18 times), and laser frequency (20~25 kHz). This research provides theoretical and experimental support for the precise control of surface texture prepared by laser processing of GH4169, laying the foundation for friction and wear tests of textured finger seals.

Surface Texturing with Laser Multiple-Spot Scanning Technology

Mechanical Seal Face Texturing by the Acousto-Optic Q-Switched Pulsed Nd:Yag Laser

The effect of laser surface texturing on frictional performance of face seal

Surface characterization and alternate of related technological parameters for LST

Study of Laser Surface Texturing for Improving Tribological Properties

Characteristic of Laser Texturing Surface Aided with Abbott Curve

Influence of typical technological parameters on the processing quality of laser surface texturing technology for finger sealing

Precision Fabrication of Micro-Textures Array for Surface Functionalization Using Picosecond Pulse Laser

Micro-dimple Surface Texture Picosecond Laser Processing and Tribological Properties

Fabrication of Interference Textures on Cemented Carbides Using Nanosecond and Femtosecond Laser Pulses

Fabrication and mechanical measurements of micro- and nano-textured surfaces induced by laser processing

Wettability-Oriented Laser Microgrooving Process on Cemented Carbide Surface

Laser Texturing of Rolled Surfaces

Study of Laser Precision Ablating Texture Patterns on Large-Scale Freeform Surface

Enhanced Tribological Property of Mechanical Seal in Water Environment by Nanosecond Laser Surface Texturing

Study on the Influence of Scanning Strategy on the Morphology of Laser Micro-Dimple Texturing

Hierarchical microtextures generated by pulsed-laser manufacturing for surface geometry modulation

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Laser Surface-micropored Improving Tribological Properties of Face Seals

Tribological Properties of Laser Surface Texturing and Coating Duplex-Treated Surface

State of the Art in Laser Surface Texturing