Abstract:Direct Laser Writing (DLW) using ultrashort pulsed lasers and galvanometer scanning, has become an established process for surface texturing, allowing an extensive variety of feature geometries and texture designs to be produced. The minimum feature sizes that can be generated are however limited by factors such as the laser output power, beam diameter, beam wavelength and associated optics. To address the need to produce even smaller texture features, Direct Laser Interference Patterning (DLIP) has been developed, which utilises bespoke beam splitting and converging optics to produce periodic interference fringing and enabling surface textures in the micrometric size range to be produced. In this study, the texturing of cast iron cylinder liner segments using DLW and DLIP processes is explored, to assess their tribological performance in high efficiency internal combustion engines, such as for hybrid applications. To facilitate the designs of textures and to capture high resolution data on surface interactions at specific points in the combustion cycle, the segmentation of cylinder lines and piston rings is undertaken. The results of tribology tests covering combinations of high and low speeds and contact pressures, have shown that the mechanical honing of cylinder liners could potentially be replaced with the cleaner DLIP texturing as an alternative. Optimised texture designs using the DLW process achieved up to a 54 % reduction in kinematic friction between the piston ring and textured cylinder liner surfaces, compared with mechanically honed cylinder liner segments. These results have indicated that DLW texturing offers the best improvement in friction performance in the boundary and mixed lubrication regimes at higher contact pressures, at both lower and higher sliding speeds. The results also provide useful comparative data on the performance of meso and micrometric scale textures and how they can be best applied to cylinder liners.

Micro-dimple Surface Texture Picosecond Laser Processing and Tribological Properties

Study of Negative Side Wall Surface Roughness by Picosecond Photonic Impact Microdeposition

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Analysis of synergistic friction reduction effect on micro-textured cemented carbide surface by laser processing

Surface Texturing for Low Friction Mechanical Components

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Surface Texturing with Laser Multiple-Spot Scanning Technology

Hierarchical microtextures generated by pulsed-laser manufacturing for surface geometry modulation

Micro-dimple textured surface produced by laser-induced particle impact test and improving tribological performance

Laser Surface Texturing of Stainless Steel − Effect of Pulse Duration on Texture's Morphology and Frictional Response

Fabrication of Interference Textures on Cemented Carbides Using Nanosecond and Femtosecond Laser Pulses

Methodology of laser processing for precise control of surface micro-topology

Laser Melting and Surface Texture Technology: Effect on Friction Properties

Mechanical Seal Face Texturing by the Acousto-Optic Q-Switched Pulsed Nd:Yag Laser

Laser Processing of Hard and Ultra-Hard Materials for Micro-Machining and Surface Engineering Applications

Tribological behavior of zirconia ceramic with micro-channels produced by nanosecond laser

Effect of picosecond laser texturing on the friction behavior of silicon carbide in hybrid ceramic bearings under dry and water lubrication

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Optimization of Micro-Texturing Process Parameters of TiAlN Coated Cutting Tools by Femtosecond Laser

Improving Tribological Performance of Mechanical Components by Laser Surface Texturing

Tribological Properties of Ti6Al4V Titanium Textured Surfaces Created by Laser: Effect of Dimple Density