Abstract:The micro-texture is a relatively well-established method for improving the tribological performance of Co-Cr-Mo alloy. Currently, to fabricate the micro-textures on the alloy surface, laser micromachining technology is the commonly used method. However, the low fabrication quality (such as irregular protrusions inside and on the edges of the micro-textures) caused by laser ablation limits the numerous application of laser surface textures. Therefore, a novel method of combining nanosecond (ns) pulse laser texturing with ion beam etching was proposed to prepare the micro-textures on the surface of Co-Cr-Mo alloy. The tribological properties before and after ion beam etching were tested by ball-disk friction wear test for three different micro-texture morphologies (grooved micro-texture (G); hexagonal micro-texture (H); concentric micro-texture (C)), and the micro-topography, mechanical properties and wettability of the ion beam/laser textured Co-Cr-Mo alloy were also investigated. The results showed that the friction coefficient and wear amount of the specimen surface were reduced after ion beam etching, and the ion beam/laser textured sample with hexagonal micro-textures showed the best wear performance, with the average friction coefficient reduced by 11.9 % and the wear amount of polyether ether ketone balls reduced by 14.9 %. The worn surface of the ion beam etched samples was relatively smooth, and the adhesive wear was also reduced. This report established the friction reduction model of ion beam/laser textured alloy and revealed the friction reduction mechanism of ion beam etching, providing a new idea of fabricating high-quality micro-textures to enhance the wear performance of artificial hip joints.

Effect of picosecond laser texturing on the friction behavior of silicon carbide in hybrid ceramic bearings under dry and water lubrication

Friction and Wear Properties of Si3N4 and SiC Used for Water-Lubricated Sliding Bearings

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Fabrication and tribological characterization of laser textured engineering ceramics: Si3N4, SiC and ZrO2

Synergistic effect of surface textures and DLC coatings for enhancing friction and wear performances of Si3N4/TiC ceramic

Analysis of synergistic friction reduction effect on micro-textured cemented carbide surface by laser processing

Wetting behavior of Al on the surface of SiC textured by nanosecond laser

Effect of ion beam etching on the tribological performance of laser textured Co-Cr-Mo alloy

Tribological behavior of zirconia ceramic with micro-channels produced by nanosecond laser

Laser Irradiation-Induced SiC@Graphene Sub-Microspheres: A Bioinspired Core-Shell Structure for Enhanced Tribology Properties

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Effect of fiber orientation on tribological properties of fiber reinforced C/C‐SiC composites mated with ceramic ball

Effect of bionic shield texture on friction behavior of Silicon Carbide under water lubrication condition

Friction Behavior of a Textured Surface against Several Materials under Dry and Lubricated Conditions

Experimental and MD simulation study of surface residual stress and surface quality of SiCp/Al in pulsed laser-ultrasonic assisted grinding

An Experimental Investigation of Tribological Performance of Triangular Textures in Water Lubrication Regime

Frictional performance of silicon carbide under different lubrication conditions

Tribological Behavior of Liquid Phase Sintered SiC Ceramics Under Dry Condition

Improving hydrophobicity of laser textured SiC surface with micro-square convexes