Abstract:Polyether-ether-ketone (PEEK) and polyimide (PI) are two kinds of engineering polymer materials widely used as roller bearing cages and rings under extreme environment because of their noise reduction and corrosion resistance properties. The Si3N4 ceramic is the most common ball bearing material. Many current engineering applications of ball bearings require aqueous lubrication. Therefore, this study presents the aqueous lubrication of tribopairs formed by PEEK and PI material sliding against Si3N4 ceramic. Experimental results show that two tribopairs exhibited the similar tribological properties under the dry condition. Water as a lubricant for the PI–Si3N4 tribopair pairs effectively reduces both friction coefficients by 35.5% and wear rates by 32%. The water absorption of PI induces better tribological properties by changing the tribopair surface properties. In addition, the dimples appearing on the PI tribopair surface under water generate additional hydrodynamic lubrication and further improve the friction properties of surface. The PEEK–Si3N4 tribopair shows similar friction coefficients under two kinds of environments. The wear rates under water are approximately more than two times of that under dry sliding. However, water inhibits the appearance of the crush phenomenon and enhances the carrying capacity of the tribopair. Energy dispersive spectroscopy and X-ray diffraction spectra demonstrate no chemical corrosion. The 3D profiler and SEM morphologies illustrate that the transfer film would be formed from the surface of PEEK under water but hindered under dry friction. Overall, the PI–Si3N4 tribopair exhibits better properties than PEEK under water and is promising for future applications in the bearing industry.

Friction and Wear Properties of Si3N4 and SiC Used for Water-Lubricated Sliding Bearings

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

The Research on Friction and Wear Properties of Silicon Carbide and Silicon Nitride

Tribological Characteristics of Silicon Nitride-chilled Cast Iron with Oil-less Lubrication

Design on Hybrid Ceramic Bearing Based on Water Based Fluid with Controllable Viscosity

Analysis on Wear Properties and Impact Factors for Si3N4 Ceramic Mated with Chilled Cast Iron

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Ni/Si3N4 composite coatings and their water lubrication behaviors

Aqueous lubrication and surface microstructures of engineering polymer materials (PEEK and PI) when sliding against Si3N4

Friction and wear performance of CrSiBCN coatings sliding against ceramic and metal counterparts in sea water

Research on Tribology Property of Si-3N-4 Ceramic and Chilled Iron under Oil-Less Lubrication

Friction and wear properties of CrSiCN coatings with low carbon content as sliding against SiC and steel balls in water

Dry sliding tribological behavior of C/SiC under different load and speed

Effect of the grease thickener on tribological properties of Si3N4/GCr15 contact interface and the performance in hybrid ceramic ball bearing

Friction and Wear of Si3N4 Ceramic/stainless Steel Sliding Contacts in Dry and Lubricated Conditions

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Friction and Wear Properties of CrSiCN/SiC Tribopairs in Water Lubrication

Effect of picosecond laser texturing on the friction behavior of silicon carbide in hybrid ceramic bearings under dry and water lubrication

Tribological behavior of various ceramic materials sliding against CF/PTFE/graphite-filled PEEK under seawater lubrication

Tribological properties of graphene/β-Si3N4 whisker reinforced Si3N4 ceramic composites

Tribological Properties of Cr(Si)CN Coatings Sliding Against Different Mating Balls in Water