Abstract:Studying the tribological behavior between diamond materials and ceramics is crucial for understanding the grinding mechanism of diamond wheels on ceramics. To comprehend the tribological characteristics between diamond materials and various ceramics, this paper presents a comparative study of the tribological behaviors of Al2O3, AlN, Si3N4, and ZrO2 ceramics sliding against polycrystalline diamond (PCD) balls. The dependence of the coefficient of friction (COF), wear characteristics as well as the surface morphology of different ceramics and SiC-bonded PCD balls on load, sliding stage were examined. The effect of nanofluids on the COF and wear of different ceramics was also investigated. The results showed that the tribological characteristics of ceramic materials are strongly dependent on mechanical properties. Al2O3 and AlN ceramics with lower fracture toughness exhibit a significantly higher COF and wear volume than that of Si3N4 and ZrO2 ceramics. Al2O3 presents the highest COF (0.38) and wear volume, and Si3N4 owns the lowest COF (0.08) and wear volume under the load of 9.8 N. By examining the wear grooves of different ceramics, it is found that Al2O3 and AlN ceramics own larger debris than that of Si3N4 and ZrO2, which also causes more smearing on the ceramic and adhesion of wear debris to the SiC-bonded PCD ball for Al2O3 and AlN. Under lubricants, the COFs and the adhesion of wear debris are effectively reduced, and the wear rate of the ceramic is increased. There is little difference between deionized (DI) water and nanofluids on the effect of lubricants on COF for Al2O3 and AlN. However, for ceramics with higher fracture toughness, the nanofluids can reduce the COFs of Si3N4 and ZrO2 in comparison with DI water.

Research on Tribology Property of Si-3N-4 Ceramic and Chilled Iron under Oil-Less Lubrication

Tribological Characteristics of Silicon Nitride-chilled Cast Iron with Oil-less Lubrication

Analysis on Wear Properties and Impact Factors for Si3N4 Ceramic Mated with Chilled Cast Iron

Friction and Wear Properties of Si3N4 and SiC Used for Water-Lubricated Sliding Bearings

The Research on Friction and Wear Properties of Silicon Carbide and Silicon Nitride

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Friction and Wear of Si3N4 Ceramic/stainless Steel Sliding Contacts in Dry and Lubricated Conditions

Friction and wear performance of CrSiBCN coatings sliding against ceramic and metal counterparts in sea water

Tribological Behavior of Liquid Phase Sintered SiC Ceramics Under Dry Condition

Investigation on the tribological properties of ceramics rubbing against stainless steel at high temperature

Dry sliding tribological behavior of C/SiC under different load and speed

Tribological Characteristics of Si3N4 Ceramic Sliding on Stainless Steel

Experimental Investigation On Surface High Temperature Wear Behaviors Of Si3n4 Ceramics For Rotary Ultrasonic Grinding

Study on tribological behaviors of Si3N4 based ceramics sliding against POM under different solutions

Ni/Si3N4 composite coatings and their water lubrication behaviors

Effects of Lubricants on Friction and Wear of Ti(Cn)/1045 Steel Sliding Pairs

Wear mechanisms of pairs of Si3N4-based and Ti(CN)-based ceramic with 1Cr18Ni9Ti stainless steel under dry-friction condition

Frictional performance of silicon carbide under different lubrication conditions

A comparative study on tribological behavior of Al2O3, AlN, Si3N4 and ZrO2 ceramics sliding against polycrystalline diamond ball

Friction and wear of a plasma sprayed Al2O3-40%ZrO2-cast iron system