Abstract:Studying the tribological behavior between diamond materials and ceramics is crucial for understanding the grinding mechanism of diamond wheels on ceramics. To comprehend the tribological characteristics between diamond materials and various ceramics, this paper presents a comparative study of the tribological behaviors of Al2O3, AlN, Si3N4, and ZrO2 ceramics sliding against polycrystalline diamond (PCD) balls. The dependence of the coefficient of friction (COF), wear characteristics as well as the surface morphology of different ceramics and SiC-bonded PCD balls on load, sliding stage were examined. The effect of nanofluids on the COF and wear of different ceramics was also investigated. The results showed that the tribological characteristics of ceramic materials are strongly dependent on mechanical properties. Al2O3 and AlN ceramics with lower fracture toughness exhibit a significantly higher COF and wear volume than that of Si3N4 and ZrO2 ceramics. Al2O3 presents the highest COF (0.38) and wear volume, and Si3N4 owns the lowest COF (0.08) and wear volume under the load of 9.8 N. By examining the wear grooves of different ceramics, it is found that Al2O3 and AlN ceramics own larger debris than that of Si3N4 and ZrO2, which also causes more smearing on the ceramic and adhesion of wear debris to the SiC-bonded PCD ball for Al2O3 and AlN. Under lubricants, the COFs and the adhesion of wear debris are effectively reduced, and the wear rate of the ceramic is increased. There is little difference between deionized (DI) water and nanofluids on the effect of lubricants on COF for Al2O3 and AlN. However, for ceramics with higher fracture toughness, the nanofluids can reduce the COFs of Si3N4 and ZrO2 in comparison with DI water.

Investigation on the tribological properties of ceramics rubbing against stainless steel at high temperature

The Thermal Stability and Lubricity of Zinc Thiomolybdenate at Temperatures Up to 500°C

Tribological Characteristics of Si3N4 Ceramic Sliding on Stainless Steel

Friction and Wear of Si3N4 Ceramic/stainless Steel Sliding Contacts in Dry and Lubricated Conditions

Wear Behavior of Al 2 O 3 -Ticn Composite Ceramic Sliding on Stainless Steel

Wear Behavior of Si3N4 Ceramic Cutting Tool Material Against Stainless Steel in Dry and Water-Lubricated Conditions

Wear mechanisms of Ti(C, N) ceramic in sliding contact with stainless steel

Tribological Behavior of Liquid Phase Sintered SiC Ceramics Under Dry Condition

Friction–wear behavior and tribochemical reactions of different ceramics in HFC-134a gas

Research on Tribology Property of Si-3N-4 Ceramic and Chilled Iron under Oil-Less Lubrication

The Analysis of the Friction and Wear Mechanisms of Plasma-Sprayed Ceramic Coatings at 450 °C

Wear mechanisms of pairs of Si3N4-based and Ti(CN)-based ceramic with 1Cr18Ni9Ti stainless steel under dry-friction condition

The Tribological and Adsorption Performance of Chlorophenyl Silicone Oil Using Different Ceramic Materials under High Temperature

A comparative study on tribological behavior of Al2O3, AlN, Si3N4 and ZrO2 ceramics sliding against polycrystalline diamond ball

Tribological properties and wear resistance mechanism of WC-ZrO2-Al2O3 ceramics

Tribological Behavior of Titanium Alloys during Friction against Ceramics

Investigation into Friction and Wear Characteristics of 316L Stainless-Steel Wire at High Temperature

High-temperature tribological properties of Si 3 N 4 /TiC ceramic with bionic surface textures and DLC coatings

Friction and wear behaviors of Al 2 O 3 /TiC micro-nano-composite ceramic sliding against metals and hard materials

Tribocorrosion behavior of 316L stainless steel sliding against different ceramics in 0.5 M H2SO4 solution

High-temperature Tribological Properties of Si3N4/TiC Ceramic with Bionic Surface Textures and DLC Coatings