Abstract:Silicon carbide (SiC) ceramic material has become the most promising third-generation semiconductor material for its excellent mechanical properties at room temperature and high temperature. However, SiC ceramic machining has serious tool wear, low machining efficiency, poor machining quality and other disadvantages due to its high hardness and high wear resistance, which limits the promotion and application of such materials. In this paper, comparison experiments of longitudinal torsional ultrasonic vibration grinding (LTUVG) and common grinding (CG) of SiC ceramics were conducted, and the longitudinal torsional ultrasonic vibration grinding SiC ceramics cutting force model was developed. In addition, the effects of ultrasonic machining parameters on cutting forces, machining quality and subsurface cracking were investigated, and the main factors and optimal parameters affecting the cutting force improvement rate were obtained by orthogonal tests. The results showed that the maximum improvement of cutting force, surface roughness and subsurface crack fracture depth by longitudinal torsional ultrasonic vibrations were 82.59%, 22.78% and 30.75%, respectively. A longitudinal torsional ultrasonic vibrations cutting force prediction model containing the parameters of tool, material properties and ultrasound was established by the removal characteristics of SiC ceramic material, ultrasonic grinding principle and brittle fracture theory. And the predicted results were in good agreement with the experimental results, and the maximum error was less than 15%. The optimum process parameters for cutting force reduction were a spindle speed of 22,000 rpm, a feed rate of 600 mm/min and a depth of cut of 0.011 mm.

Experimental Investigation On Surface High Temperature Wear Behaviors Of Si3n4 Ceramics For Rotary Ultrasonic Grinding

An Experimental Investigation on Ultrasonic Vibration-Assisted Grinding of Sio2f/Sio2 Composites

Analysis on Wear Properties and Impact Factors for Si3N4 Ceramic Mated with Chilled Cast Iron

Friction and Wear Properties of Si3N4 and SiC Used for Water-Lubricated Sliding Bearings

Studies on the Surface Quality of the Unsteady-State Grinding Technique

Experimental Reasearch on Grinding Surface Waviness of Engineering Ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Study on the removal mechanism of Si3N4 ceramic material in rotary ultrasonic grinding based on multi-abrasive coupling simulation

Effect of grinding parameters on surface quality in internal grinding of silicon nitride ceramics

Theoretical and Experimental Investigation on Inclined Ultrasonic Elliptical Vibration Cutting of Alumina Ceramics

Effects of Grinding Parameters on the Processing Temperature, Crack Propagation and Residual Stress in Silicon Nitride Ceramics

Investigation on the Surface Morphology of Si3N4 Ceramics by a New Fractal Dimension Calculation Method

Research on Tribology Property of Si-3N-4 Ceramic and Chilled Iron under Oil-Less Lubrication

Precision Grinding Technology of Silicon Carbide (SiC) Ceramics by Longitudinal Torsional Ultrasonic Vibrations

Tribological Behavior of Liquid Phase Sintered SiC Ceramics Under Dry Condition

Friction and Wear of Si3N4 Ceramic/stainless Steel Sliding Contacts in Dry and Lubricated Conditions

Wear Behaviour of High Strength Tool Steel 90MnCrV8 in Contact with Si3N4

The Exposure Height of Silicon Particle with Round Edges Effect on the Tribological Property of Al-Si Alloy Cylinder Liner

Erosion wear characteristics and mechanism of Si3N4 ceramics: Effect of impact angle

Erosive Wear Performance and Mechanism of Engineering Ceramic Materials

Wear Behavior of Si3N4 Ceramic Cutting Tool Material Against Stainless Steel in Dry and Water-Lubricated Conditions