Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Classification Of Fundamental Ferroresonance, Single Phase-To-Ground And Wire Breakage Over-Voltages In Isolated Neutral Networks

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Study on simulation of ferroresonance elimination in 10kV power system

Single Phase Ferroresonance Detection and Type Recognition in Solidly Grounded Power Grid

Single Line-to-Ground Fault Type Multilevel Classification in Distribution Network Using Realistic Recorded Waveform

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Identification of Permanent Fault at Transmission Lines with Shunt Reactors Based on Waveform Correlation

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Analysis and Detection of High Impedance Grounding Fault in Neutral Point Effectively Grounding Distribution Network

Single phase to ground arcing fault identification based on wavelet packet energy

Faulty Feeder Detection Under High Impedance Faults for Resonant Grounding Distribution Systems

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

Fault Handling and Localization Strategy Based on Waveform Characteristics Recognition with Coordination of Peterson Coil and Resistance Grounding Method

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Nonlinearity Characteristic of High Impedance Fault at Resonant Distribution Networks: Theoretical Basis to Identify the Faulty Feeder

An Identification Method for Asymmetric Faults With Line Breaks Based on Low-Voltage Side Data in Distribution Networks

An online energy-tracking-based approach for fault-identification applies to the NUGS

Single phase to ground fault location method of overhead line based on magnetic field detection and multi-criteria fusion

Faulty Feeder Detection Method Based on VMD–FFT and Pearson Correlation Coefficient of Non-Power Frequency Component in Resonant Grounded Systems