Abstract:Microvia interconnection technology, which mainly includes blind via and buried via, has been put forward to meet the trends of ldquofaster, lighter, reliablerdquo in electronic industry. The technology plays a crucial role in the development of low cost and high density printed circuit board (PCB). However, as the cost for raw materials, like copper, keeps increasing, one defect blind via will lead to not only failure of the whole board but great economic loss as well. The defect causes and mechanisms have been diversified due to the complexity of process, which can be traced back to material property, microvia design, manufacturing process and service environment etc.. This paper focuses on systematic failure analysis of blind vias on PCB for novel mobile phones. A series of modern analytical instruments and methods were used to observe defects of the vias. Meanwhile, focused ion beam (FIB) was adopted, for the first time, both at home and abroad, to obtain the microstructure of copper grains in the cracking interface. Characterization techniques such as FT-IR, TGA and SAM were also performed to inspect thermal stability of the bare boards. The results have shown that obvious cracking occurring along the interface of different plating layers is the main cause of open circuit; and that both sulfur impurity on wall of the vias related to incomplete desmear process and inappropriate location of the vias concerned with circuit design predominantly account for blind vias cracking. It has been revealed that the reason of the cracking generation is concerned with the sulfur segregation and the formation of brittle CuxS (1lesxles2). Moreover, the influence of warpage on the reliability of the via has also been mentioned. Based on these defaults, improvement countermeasures and suggestions have been addressed in the paper, which are of significant value for reference to the safe reliability and structural integrity of PCB products during manufacturing and servic- - es.

Application of Ultraviolet Laser in High Density Interconection Micro Blind Via

Research on blind via drilling using UV laser

The laser drilling of high density interconnect (HDI) technology manufacture and application

A Parameters Optimization of the CO2 Laser Drilling Process for HDI Microvia Fabrication

High Throughput Laser Nano Direct Writing Technique

Research on the process of Micro buried/blind Via in HDI rigid-flex PCB

Research on Manufacturing Process of Buried/Blind Via in Hdi Rigid-Flex Board

Fabricating research of two-depth micro blind via with copper filled in HDI PCB

Research on Laser Micro Via Processing in Rigid and Flexible Substrate Materials

Co2 Laser Induced Blind-Via for Direct Electroplating

Investigation of through micropatterns fabrication on C194 copper foil by ultraviolet nanosecond pulsed laser microdrilling

The study on improving microvia-filling plating

Mechanical Drilling of Pcb Micro Hole and Its Application in Micro Ultrasonic Powder Molding

Laser Drilling of High-Density Through Glass Vias (TGVs) for 2.5D and 3D Packaging

Application research on slot-cutting by UV laser in rigid-lfex PCB

Characterization of Micro-Holes Drilled Using a UV Femtosecond Laser in Modified Polyimide Flexible Circuit Boards

Study on thin surface copper technology in blind via iflling plating

Parametric optimization of hole taper control in ultraviolet nanosecond laser micro-drilling of copper foil

Uv Laser Cutting of Glass-Epoxy Material for Opening Flexible Areas of Rigid-Flex Pcb

Micro hole drilling of high frequency printed circuit board containing hard fillers

Analysis on cracking blind vias of PCB for mobile phones