Abstract:PurposeThe purpose of this paper is to study an electrolytic etching method to prepare fine lines on printed circuit board (PCB). And the influence of organics on the side corrosion protection of PCB fine lines during electrolytic etching is studied in detail. Design/methodology/approachIn this paper, the etching factor of PCB fine lines produced by new method and the traditional method was analyzed by the metallographic microscope. In addition, field emission scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS) were used to study the inhibition of undercut of the four organometallic corrosion inhibitors with 2,5-dimercapto-1,3,4-thiadiazole, benzotriazole, l-phenylalanine and l-tryptophan in the electrolytic etching process. FindingsThe SEM results show that corrosion inhibitors can greatly inhibit undercut of PCB fine lines during electrolytic etching process. XPS results indicate that N and S atoms on corrosion inhibitors can form covalent bonds with copper during electrolytic etching process, which can be adsorbed on sidewall of PCB fine lines to form a dense protective film, thereby inhibiting undercut of PCB fine lines. Quantum chemical calculations show that four corrosion inhibitor molecules tend to be parallel to copper surface and adsorb on copper surface in an optimal form. COMSOL Multiphysics simulation revealed that there is a significant difference in the amount of corrosion inhibitor adsorbed on sidewall of the fine line and the etching area. Originality/valueAs a clean production technology, electrolytic etching method has a good development indicator for the production of high-quality fine lines in PCB industry in the future. And it is of great significance in saving resources and reducing environmental pollution.

Study on thin surface copper technology in blind via iflling plating

Wetting Process of Copper Filling in Through Silicon Vias

Study on plating filling in blind hole by horizontal plating for HDI PCB

Study on the technology of simultaneous through-hole metallization and blind hole filled copper

Fabricating research of two-depth micro blind via with copper filled in HDI PCB

Effect of Copper Sulfate and Sulfuric Acid on Blind Hole Filling of HDI Circuit Boards by Electroplating

Manufacturing of Fine Lines by Semi-additive Process with Electroplating

Research on the process of Micro buried/blind Via in HDI rigid-flex PCB

The study on improving microvia-filling plating

Recent Advances in Electroplating of Through-Hole Copper Interconnection

Factors governing filling of blind via and through hole in electroplating

Copper electroplating technology for microvia filling

Study on fine lines and undercut suppression of printed circuit board prepared by electrolytic etching

Research and optimization of through holes and fine lines with simultaneous electroplating

Research on Manufacturing Process of Buried/Blind Via in Hdi Rigid-Flex Board

Effects Of Additives On Filling Blind Vias For Hdi Manufacture

Co2 Laser Induced Blind-Via for Direct Electroplating

High Speed Copper Plating Process for IC Substrate

Bottom-up Copper Plating to Form Stacked Interconnection of HDI Printed Circuit Board for Optical Module Application

Improved Electrochemical Plating for Void-Free Copper Line in ULSI Interconnect

Very High Aspect Ratio (AR>10) through Glass Hole (TGH) Filling in Stagnant Condition By Using DC Plating for Advanced Interposer Applications