Abstract:In this paper, wetting process of copper filling in through silicon vias was investigated by agitation and vacuum pretreatment. Copper filling followed the pretreatment was fabricated in electrolyte with optimal additives concentration. By agitation pretreatment, a large void was observed at the bottom of the vias where the copper seed layer was clearly seen, which was attributed to the insufficient wetting of vias. In the blind vias with higher aspect ratio, the ambient gas phase was difficult to be completely removed from the vias by agitation. This resulted in electrolyte having better wettability does not reach all the places of the vias by capillarity. The vacuum pretreatment results suggested that the air inside the vias was almost completely evacuated. Hence, the deionized water used as wetting solution easily permeated the blind vias relying on atmospheric pressure. Consequently, the uniform, complete and void-free copper filling was achieved due to better wettability of 273 K deionized water. Nevertheless, deionized water with temperature higher than the critical vaporization temperature yielded a void formation at the bottom of the vias, which resulted from the insufficient wetting caused by the vaporization of deionized water. The conclusions drawn by the experimental results were employed in the through silicon vias, and void-free copper filling in the vias having aspect ratio as high as 16 was fabricated. (C) 2015 Elsevier B.V. All rights reserved.

Effects Of Additives On Filling Blind Vias For Hdi Manufacture

Potential-Dependence Of Additives Distribution In Copper Electrodeposition Via Filling

Influence of Electroplating Current Density on Through Silicon Via Filling

Wetting Process of Copper Filling in Through Silicon Vias

Modeling the Bottom-Up Filling of Through Silicon Vias with Different Additives

Electrochemical Analysis of Cathode in TSV Copper Electroplating

The Synergistic Effects of Additives on the Micro Vias Copper Filling

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Influence of Convection-Dependent Adsorption of Additives on Microvia Filling by Copper Electroplating

Understanding Effect of Additives in Copper Electroplating Filling for Through Silicon Via

Evaluating the Via Filling Performance with Thin Surface Cu by the Synergistic Effect of Different Additives

Evaluating Copper Plating Process for Filling Micro Vias with Thin Surface Cu by the 1-(4-carboxyphenyl)-5-mercapto-1h-tetrazole Additive

Influence of Leveler Concentration on Copper Electrodeposition for Through Silicon Via Filling

Effect of Copper Sulfate and Sulfuric Acid on Blind Hole Filling of HDI Circuit Boards by Electroplating

Effect of additives on copper electroplating profile for TSV filling

Factors governing filling of blind via and through hole in electroplating

Investigations of the electrochemical performance and filling effects of additives on electroplating process of TSV

Synergistic Effect of Additives on Filling of Tapered TGV Vias by Copper Electroplating

Quick Development Of Copper Electroplating Formula For Via And Trench Filling By An Experiential Method

Electrochemical behaviors of additives in high Cu(II) concentration solution for high-aspect-ratio through ceramic holes filling

Synergistic Effect of Different Additives on Microvia Filling in an Acidic Copper Plating Solution