Abstract:The integrated circuit (IC) substrate occupies an interesting place in electronic devices. They serve as the bridge between the integrated circuits and the PCB. In this connecting point, they must meet the requirements of both worlds. They must provide the high density of connections to match the IC chip, while at the same time be a stable and robust platform for the chip to reside on. The IC substrate feature sizes and uniformity requirements are moving closer to what is required in the semi-conductor industry, except these substrates must be made at a scale, speed, and cost expected in the PCB industry. In this paper, we present an acid copper electrolyte for plating 2 in 1 redistribution layers (RDL), with small vias and fine lines down to 10μm wide. The electrolytic process successfully plates these features, while maintaining a uniform surface across the panel. The 510 mm x 515 mm panel had less than 5% variation in Cu thickness. The electrolyte was evaluated in a vertical continuous plating (VCP) style tool and a tool that plates panels at high speed. The standard VCP tool operated around 1.0 – 3.0 ASD, whereas the high-speed plater operated around 4.5 – 6.5 ASD. The obvious benefit of the high-speed tool was to reduce the plating time, but it also provided new degrees of control that are not available in VCPs. In either tool, the electrolyte performed well and produced uniform deposits that met the physical requirements that IC substrate applications demand.

Bottom-up Copper Plating to Form Stacked Interconnection of HDI Printed Circuit Board for Optical Module Application

Plating Uniformity of Bottom-Up Copper Pillars and Patterns for Ic Substrates with Additive-Assisted Electrodeposition

Study on plating filling in blind hole by horizontal plating for HDI PCB

Improving Wettability of Photo-Resistive Film Surface with Plasma Surface Modification for Coplanar Copper Pillar Plating of IC Substrates

Study on the technology of simultaneous through-hole metallization and blind hole filled copper

Numerical Simulation of Optimizing Plating Uniformity of Interconnect Circuits on Printed Circuit Boards

High Speed Copper Plating Process for IC Substrate

Optimization of High-Speed Electrolytic Plating of Copper Pillar to Achieve a Flat Top Morphology and Height Uniformity

Design of metalized polyether-ether-ether-ketone based on semi-additive manufacture for 5G applications: from bottom-up assembly to selective electroplating

Fabricating research of two-depth micro blind via with copper filled in HDI PCB

Study on thin surface copper technology in blind via iflling plating

Effect of Copper Sulfate and Sulfuric Acid on Blind Hole Filling of HDI Circuit Boards by Electroplating

Bottom-up Copper Electroplating Using Transfer Wafers for Fabrication of High Aspect-Ratio Through-Silicon-vias

Very High Aspect Ratio (AR>10) through Glass Hole (TGH) Filling in Stagnant Condition By Using DC Plating for Advanced Interposer Applications

Improvement of Plating Uniformity for Copper Patterns of IC Substrate with Multi-Physics Coupling Simulation

High Aspect Ratio Copper Through-Silicon-vias for 3D Integration

Top Metal Layer Electro Plating Edge Bevel Removal Improvement Study

Copper Induced Direct CO2 Laser Drilling Blind Hole with the Aid of Brown Oxidation for PCB CCL

Interface Adhesion Enhancement by Condensed Aromatic Ring Expansion of Naphthalene Imide Derivatives for Microvia Metallization by Copper Electroplating

Copper Coin-Embedded Printed Circuit Board for Heat Dissipation: Manufacture, Thermal Simulation and Reliability

A High Copper Concentration Copper-Quadrol Complex Electroless Solution for Chip Bonding Applications