Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Research on Grounding Method of Arc-Suppression Coil with Parallel or Serial Resistance and Ground-Fault Protection Principle

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Study on Single-Phase Grounding Current Protection of Distribution Line in Neutral Grounding System Via Arc Suppression Coil

Study on High Impedance Grounding Fault Protection for Personal Safety Guard in Distribution Grid

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Research of Neutral Grounding Modes for 20 Kv Distribution Network

Research on Arc-Suppression and Fault Line Selection of Single-Phase-to-ground Fault in Resonant Grounded Systems

A review of single-phase-to-ground fault regulation devices for distribution networks

Research of neutral grounding modes for 20kV distribution network

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

A Study of the Digital Grounding Fault Protection Scheme for Excitation Winding of Generator

A Non-neutral alternate arc suppression method for single phase grounding fault in active distribution network

Research on Protection Coordination Between Flexible DC System and Breaker

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

Investigation on test schemes for grounding grids corrosion diagnosis

Study on simulation of ferroresonance elimination in 10kV power system

A Novel Topology for Grounding Fault Voltage Compensation Based on Voltage Clamping

A novel voltage arc suppression method for single-phase grounding fault in distribution network based on power router

Analysis And Improvement On Stator Earth-Fault Protection By Injecting 20hz Signal

Analysis and Improvement on Stator Earth-Fault Protection by Injecting 20 Hz Signal