Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

A Novel Topology for Grounding Fault Voltage Compensation Based on Voltage Clamping

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

A Novel Topology of DC Distribution Network with Fault Current Limiting Static Synchronous Series Compensator

Design Of A Novel Bridge-Type Fcl And Its Application In Upfc

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

Topology of Current-Limiting and Energy-Transferring DC Circuit Breaker for DC Distribution Networks

A Non-neutral alternate arc suppression method for single phase grounding fault in active distribution network

Topology Modeling and Design of a Novel Magnetic Coupling Fault Current Limiter for VSC DC Grids

A novel voltage arc suppression method for single-phase grounding fault in distribution network based on power router

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

A Novel Six-Leg Three-Phase Fault Current Limiter

Faulted terminal open circuit voltage controller for arc suppression in distribution network

A Novel Fast Energy Storage Fault Current Limiter Topology for High-Voltage Direct Current Transmission System

Double closed loop PI control with full compensation arc elimination based on zero sequence voltage of neutral point

New topology for unbalance compensation of cascaded STATCOM with star configuration

Study on Single-Phase Grounding Current Protection of Distribution Line in Neutral Grounding System Via Arc Suppression Coil

A flexible compensation device for single-phase-to-ground fault in distribution networks based on double-loop passivity-based control

Reliability-Enhanced Hybrid Grounding System Based on Active Neutral-Point Voltage Regulator and Low-Resistance

A NOVEL TOPOLOGY OF SOLID STATE FAULT CURRENT LIMITER AND ITS CONTROL STRATEGY

A Novel Auto-transformer Coupling Bridge-type SSFCL and Its Topology Improvement