Abstract:Aiming at the problem of zero sequence voltage generated by unbalance parameters of line to ground, which affects arc suppression effect of grounding fault of controllable voltage source. By analyzing the influence of ground unbalance parameters on the arc suppression effect of controllable voltage source under different grounding modes, the mechanism of full compensation arc suppression based on zero sequence voltage of neutral point is revealed, and on this basis, a fully compensated arc suppression model of controllable voltage source controlled by double closed loop PI is established, and the deviation control is carried out by using the neutral voltage of distribution network and the voltage of fault phase supply. The residual voltage ring adopts the ground fault phase residual voltage for closed loop control. The simulation results show that the dual-closed-loop PI control algorithm can continuously stabilize the output waveform of the controllable voltage source. When the transition resistance is 0.1 ~ 10 kΩ, the residual voltage stabilization time of the independent controllable voltage source grounding method is 43 ms ~ 2.4 s, and the parallel arc suppression coil grounding method is 43 ms ~ 4.7 s. The proposed dual closed-loop PI control method for neutral point voltage deviation and fault residual voltage can stabilize the residual voltage of the grounded fault phase to below 10 V, forcing reliable arc extinction at the grounded fault point, exhibiting good stability. Low-voltage simulation tests have also proved the feasibility of the algorithm.

A flexible compensation device for single-phase-to-ground fault in distribution networks based on double-loop passivity-based control

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

A Current Compensation Method for Single-Phase-to-Earth Fault in Distribution Networks

Control strategy designing of hybrid compensator based on APF and TSC

Fast-transient repetitive controller based current control strategy for a cascaded DSTATCOM

Flexible DC System Fault Analysis

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Improved Scheme for Single-Ground Fault Suppression Based on Grounded-Fault Transfer Device

Control Method Of Single-Phase Inverter Based Grounding System In Distribution Networks

A Multi-Modular Shunt Active Power Filter System and Its Novel Fault-Tolerant Strategy Based on Split-Phase Control and Real-Time Bus Communication.

Design and Simulation of Fault Current Limiter with Series Compensation

A New Principle of Active Arc Suppression for Distribution Network Based on Constant Fault Phase Current

A novel flexible fault eliminator with active disturbance rejection and soft grid-connection in distribution networks

Fast Repetitive Controller Based Individual Phase Control Strategy for Cascaded DSTATCOM.

System Modeling and Cascaded Passivity Based Control for Distribution Transformer Integrated with Static Synchronous Compensator

Single-line-to-ground Fault Location in the Compensated Distribution Network

Cascade model predictive control strategy for medium voltage flexible interconnected systems with arc suppression capability under single phase grounding fault

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

A Non-neutral alternate arc suppression method for single phase grounding fault in active distribution network

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

Double closed loop PI control with full compensation arc elimination based on zero sequence voltage of neutral point