Abstract:Chiplet-based packaging technology integrates multiple heterogeneous dies with different functions and materials into a single system as a LEGO-based approach using advanced packaging technology. However, it also brings new challenges in the thermal design aspect and thermal crosstalk between chiplets. In this article, the thermal modeling of a chiplet-based packaging with a 2.5-D interposer was carried out. Two chiplets were mounted on the interposer side-by-side. A Cu lid was attached to the top surfaces of the chiplets and periphery of the interposer through the thermal interface material1 (TIM1) and adhesive, respectively. To further dissipate the heat from the top side, a heat sink was attached to the top surface of the lid through a layer of TIM2. The effects of the TIM type, bonding approach between chiplets and interposer, heat sink structure, thermal crosstalk, convective heat transfer coefficient above the lid, and thermal design power (TDP) were analyzed. The study results show that the bumpless interconnect is beneficial for the heat dissipation of the chiplet-based packaging. The staggered column fin can exhibit superior cooling performance. The short pitch would bring cooling challenges for fine-pitch multiple chiplets integration. The temperature is decreased rapidly first and then slowed down with the increase of convective heat transfer coefficient above the lid. Under 10 000 W/ $\text{m}^{2}\cdot \text{K}$ , the maximum TDP was about 250 W.

Direct chip attachment packaging of 2D thermal flow sensor

Direct Chip Attachment Packaging of a 2-D Thermal Flow Sensor

Flip-Chip Packaging for a Two-Dimensional Thermal Flow Sensor Using a Copper Pillar Bump Technology

Ceramic Thermal Wind Sensor Based on Advanced Direct Chip Attaching Package

Flip-Chip on Board Packaging of A Thermal Wind Sensor

A Flip-Chip Packaged CMOS Thermal Flow Sensor

A Self-Packaged Thermal Flow Sensor by CMOS MEMS Technology

A Flip Chip Package for Thermal Mass Flowmeter

An Integrated Circuit Compatible Compact Package for Thermal Gas Flowmeters

A System-Level Package of MEMS Thermal Flow Sensor

Systematic Study of Packaging Designs on the Performance of CMOS Thermoresistive Micro Calorimetric Flow Sensors

Wafer Level Packaging Based on AU-AU Bonding for a CMOS Compatible Thermal Wind Sensor

Performance Enhanced Thermal Flow Sensor with Novel Dual-Heater Structure Using CMOS Compatible Fabrication Process

Annular-Encapsulation Packaging To Realize High-Performance Mems Thermal Wind Sensor

Silicon Thermal Flow Sensor Based On Ceramic Substrate

Thermal Modeling of a Chiplet-Based Packaging with a 2.5-D Through-Silicon Via Interposer

Fabrication of Flexible Thermal Thin-film Sensor Array

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

Design and Fabrication of a MEMS Temperature and Pressure Integrated Sensor with Back-Inlet Package Structure

A FCOB packaged thermal wind sensor with compensation

Design of Thermal Liquid Flow Microsensor