Abstract:As a key factor affecting thermal behaviors of liquid hydrogen (LH2) tanks, heat leakage plays an important role in accurate prediction of pressure build-up for safe storage and transportation of LH2. Uniform heat flux between vapor and liquid in LH2 tanks is widely adopted as thermal boundary condition in predicting pressure build-up process. However, a distribution of heat flux between vapor and liquid was observed during the self -pressurization process in the experimental test. In light of this, an analytically theoret-ical model of revealing the energy exchange process among the vapor, liquid and inner wall is proposed to investigate the heat leakage distribution ratio (HDR) between vapor and liquid in LH2 tanks. The feasibility of the model is validated by the experimental results from NASA. In the whole self-pressurization process of 25,000 s, HDR reduces from 0.803 to 0.235 under a liquid fill ratio of 90% and a total heat leakage of 71.3 W. The results show that the existence of inner wall and different thermal properties between the vapor and liquid make the heat leakage flux non-uniformly distributed into the vapor and liquid. And the geometric structure of tank, thermal properties and initial states of the vapor and liquid have a significant effect on HDR. When coupling the model with thermal multi-zone model, the relative error in pressure prediction is reduced by 61.8% against experimental results. Benefiting from the coupled model, the relative error in pressure prediction caused by the uniform heat flux boundary condition reduces from 90.16% to 8.15%. The present work establishes theoretical foundation on analyzing heat leakage distribution between the vapor and liquid for LH2 tanks, and provides useful guidance on modifying boundary conditions in accurately predicting thermal behaviors of LH2 tanks.(c) 2023 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Study on Leak Rate of Gas Medium in Leak-Before-Break Technique-Ii: Theoretical Studies

Leak Detection Design for ITER GIS Gas Fueling Manifold

Leak Rate Calculation for Lbb Analysis in High Temperature Gas-Cooled Reactors

Leakage Rate of Gas in Leak-Before-break Technique

Overview of Leak Rate Models for Leak Before Break Analysis

Research on Improving the System Sensitivity for Hot Helium Leak Test

Numerical Study of Hydrogen Leakage and Explosion in Hydrogen Refueling Station with Large Volume Hydrogen Storage Vessels

Development of Leak Rate Model for Helium Flow in Elliptically Converging Through Wall Crack

Theoretical investigation on heat leakage distribution between vapor and liquid in liquid hydrogen tanks

Leak Model and Numerical Simulation of Pressure Vessel Based on Joule-Thomson Effect

Study on the Break Accidents of the Htr-Pm Primary Loop

Impact of Pressure Difference on Leakage Rate from Rigid Positive Standard Leak:A Theoretical and Experimental Study

Study on the Joule-Thomson Effect During Leakage in High Pressure Vessels

A Simplified Leak-Before-break Analysis Method of Pressured Pipes

Simulation study on transport characteristics of leakage gas from the condenser of power plant

Effect of the Joule-Thomson Cooling on the Leak-Before-break Approach

The Numerical Simulation Research of Gas–Liquid Two-Phase Flow in Small-Break Loss-of-Coolant Accidents

Research about the Uniform Field Breakdown Strength of Helium Gas at High Temperature and Pressure in Millimeter-Scale Gaps

Simulation experiment study on LOCA at upper plenum of nuclear heating reactor

Study of Joule-Thomson Cooling Effect Due to Leakage in Compressed Gas Pressure Vessels

A Thermohydrodynamic Analysis of Dry Gas Seals for High-Temperature Gas-Cooled Reactor