Abstract:The force equilibrium and moment equilibrium play a significant role on the sealing performance of gas split floating ring seals. A small deflection angle may generate seriously wear on sealing surface and cause seal failure. Therefore, the thermo-hydrodynamic lubrication analysis of gas split floating ring seal with Rayleigh grooves is investigated considering the deflection angle and frictional heat of surface contact, which is beneficial to grasp the hydrodynamic characteristics and rules under high-temperature and high-speed conditions. Pressure and temperature distributions of sealing rings are numerically calculated for the cases with different deflection angle, rational speed, seal pressure and ambient temperature. Then, the hydrodynamic effect and sealing performance are analyzed. The obtained results show that, the surface Rayleigh step grooves do not present obvious hydrodynamic effect when split seal ring has no deflection. While, a significant hydrodynamic effect can be obtained when the split seal ring presents a deflection angle about dozens of micro radians. Here, a 10% increase of opening force is achieved when the deflection angle reaches 80 μrad in the case of speed 30,000 r/min and seal pressure 0.2 MPa. Moreover, the hydrodynamic effect becomes obvious with increasing deflection angle as well as rotational speed. Meanwhile, the growth of rotational speed results in an obvious increase of film temperature. The increase of ambient temperature has a significant influence on the decrease of leakage rate. When the ambient temperature increases from 340 K to 540 K, the leakage rate reduces exceeding 50%, however, it does not present obvious effect on the opening force. The proposed model has the potential to provide the theoretical basis and design guidance for surface grooves of gas split floating ring seal in the future.

A Thermohydrodynamic Analysis of Dry Gas Seals for High-Temperature Gas-Cooled Reactor

Study on the Thermo-Hydrodynamic of a Dry Gas Seal in Helium Circulator for High Temperature Gas-Cooled Reactor

Thermo-hydrodynamic analysis of spiral groove dry gas seals

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

Design and Analysis of Cooling Structure for Dry Gas Seal Chamber of Supercritical Carbon Dioxide Turbine Shaft End

Thermal Fluid-Solid Interaction Model and Experimental Validation for Hydrostatic Mechanical Face Seals

Leak Rate Calculation for Lbb Analysis in High Temperature Gas-Cooled Reactors

A CFD Method for Thermal-Hydraulic Calculation of Pebble Bed HTGRs

Numerical Simulation of Flow Field in Hot Gas Chamber of High-Temperature Gas-Cooled Reactor

Thermoelastohydrodynamic Behavior of Gas Spiral Groove Face Seals Operating at High Pressure and Speed

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Experimental and Numerical Study on Pressure Distribution of 90° Elbow for Flow Measurement

Thermal Cavitation Effect on the Hydrodynamic Performance of Spiral Groove Liquid Face Seals

Research on Heat Transfer Coefficient of Spiral Groove Dry Gas Seals

Thermo-Hydrodynamic Effect of Gas Split Floating Ring Seal with Rayleigh Step Grooves

Calculation and verification of flow field in supercritical carbon dioxide dry gas seal based on turbulent adiabatic flow model

ICONE23-2161 THERMAL-HYDRAULIC AND FLOW INSTABILITY ANALYSIS OF AN HTGR SUPERCRITICAL HELICAL TUBE STEAM GENERATOR

Three-Dimensional Flow–Heat Coupling Model of a Wavy-Tilt-Dam Mechanical Seal

Investigation of Flow and Heat Transfer in the Pebble Bed of the High Temperature Gas-cooled Reactor

Numerical Simulation of Supercritical Carbon Dioxide Dry Gas Seal

Simulations of the Thermal-Hydraulics in a High Temperature Gas-Cooled Reactor Based on the Pressure Correction Method