Abstract:As a key factor affecting thermal behaviors of liquid hydrogen (LH2) tanks, heat leakage plays an important role in accurate prediction of pressure build-up for safe storage and transportation of LH2. Uniform heat flux between vapor and liquid in LH2 tanks is widely adopted as thermal boundary condition in predicting pressure build-up process. However, a distribution of heat flux between vapor and liquid was observed during the self -pressurization process in the experimental test. In light of this, an analytically theoret-ical model of revealing the energy exchange process among the vapor, liquid and inner wall is proposed to investigate the heat leakage distribution ratio (HDR) between vapor and liquid in LH2 tanks. The feasibility of the model is validated by the experimental results from NASA. In the whole self-pressurization process of 25,000 s, HDR reduces from 0.803 to 0.235 under a liquid fill ratio of 90% and a total heat leakage of 71.3 W. The results show that the existence of inner wall and different thermal properties between the vapor and liquid make the heat leakage flux non-uniformly distributed into the vapor and liquid. And the geometric structure of tank, thermal properties and initial states of the vapor and liquid have a significant effect on HDR. When coupling the model with thermal multi-zone model, the relative error in pressure prediction is reduced by 61.8% against experimental results. Benefiting from the coupled model, the relative error in pressure prediction caused by the uniform heat flux boundary condition reduces from 90.16% to 8.15%. The present work establishes theoretical foundation on analyzing heat leakage distribution between the vapor and liquid for LH2 tanks, and provides useful guidance on modifying boundary conditions in accurately predicting thermal behaviors of LH2 tanks.(c) 2023 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Study on the Joule-Thomson Effect During Leakage in High Pressure Vessels

Study of Joule-Thomson Cooling Effect Due to Leakage in Compressed Gas Pressure Vessels

Effect of the Joule-Thomson Cooling on the Leak-Before-break Approach

Leak Model and Numerical Simulation of Pressure Vessel Based on Joule-Thomson Effect

Study on Heat Transfer Process During Leaks of High Pressure Argon Through A Realistic Crack

Numerical Simulation on Hydrogen Induced Cracking Behavior of 4130X Hydrogen Storage Vessel with Defect

Crack Growth Analysis Of High-Pressure Equipment For Hydrogen Storage

Failure research of T-joint at liquefied natural gas tanker

Experimental Research on the Two-Phase Explosive Boiling Mechanism of Superheated Liquid under Different Leakage Conditions

Experimental Study on the Flow and Thermal Characteristics of Two-Phase Leakage Through Micro Crack

Theoretical investigation on heat leakage distribution between vapor and liquid in liquid hydrogen tanks

Leak Rates of High Pressure Steam–water Across Simulation Crack

Experimental Study on Leak Flow Rate Characteristics of High Pressure Subcooled Water Through Axial and Circumferential Microcracks of Steam Generator Tubes under High Back Pressure Conditions

Experimental Investigations on Leak Flow Rate Characteristics of Water Through Axial Artificial Microcracks of Steam Generator Tubes under Back Pressure Conditions

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and L-Cr Waves

An Experimental Study on the Leakage Process of High Pressure Co2 from A Pipeline Transport System

A study on the actual heat leak of a cryogenic vessel during storage

LBB Leak Rate Calculation and Thermodynamic Non-equilibrium Effect Evaluation

Investigation of heat leakage calculations and experiments for a wide-mouth liquid nitrogen tank

Mutual Effects Between Dynamic Leakage Behavior and the Pressure/temperature in a LNG Tank with External Heat Fluxes

Study on Cooling Capacity Characteristics of an Open-Cycle Joule-Thomson Cryocooler Working at Liquid Helium Temperature