Abstract:The ellipticity involved in the Deshpande-Fleck foam model describing the constitutive behaviour of cellular materials was usually considered to be constant, but some very different values were suggested in the literature. A cell-based finite element model of closed-cell foam under uni-/multi-axial compression is employed to verify the Deshpande-Fleck foam model. The ellipticity is determined by applying uniaxial and hydrostatic compression tests and it is found to vary with the equivalent plastic strain, i.e., the ellipticity decreases with the equivalent plastic strain and then increases sustainably before full densification. According to the understandings from the numerical results, a fitting relation between the ellipticity and the equivalent plastic strain is suggested. The ellipticities of an open-cell foam and a closed-cell foam studied experimentally in the literature are fitted well with this relation. A modification to the Deshpande-Fleck foam model with a variable ellipticity is thus proposed. The modified Deshpande-Fleck foam model brings much accurate predictions with using a rigid-plastic hardening (RPH) idealisation model, which describes the stress-strain relation of cellular material under uniaxial compression. Good agreement is also observed between the experimentally measured stress-strain responses and the predictions of the modified Deshpande-Fleck foam model, especially when considering the effect of the plastic Poisson's ratio with a non-associated flow rule. The findings herein are helpful to improve the prediction accuracy of the Deshpande-Fleck foam model.

FINITE ELEMENT ANALYSIS OF ELASTIC PROPERTIES OF OPEN-CELL AND CLOSED-CELL FOAM BASED ON THREE KIND OF CELL MODELS

FINITE ELEMENT ANALYSIS FOR THE ELASTIC MODULUS OF OPEN-CELL FOAMS BASED ON A TETRAKAIDECAHEDRON MODEL

A numerical study of the elastic properties of low density open-cell foams with tetrakaidecahedral cells

Three-dimensional modeling of the mechanical property of linearly elastic open cell foams

THE MECHANICAL BEHAVIORS OF CLOSED-CELL ALUMINUM-ALLOY FOAMS WITH SPHERICAL PORES

Numerical Modeling of the Compression Process of Elastic Open-cell Foams

Numerical Analysis of Elastoplastic Behavior of Foams with Ellipsoidal Pores

Investigation on elastic properties of closed-cell Voronoi foam

Investigation into elastic properties of anisotropic random foam model

Analysis and Simulation for Tensile Behavior of Anisotropic Open-Cell Elastic Foams

NUMERICAL ANALYSIS OF THE CREEP AND STRESS RELAXATION OF LOW DENSITY OPEN-CELL FOAMS

Numerical Modeling of the Fracture Behavior of Open Cell Foams

A new modelling method for open cell foam structure based on centroidal and capacity constraint power diagram

Analysis and simulation of high strain compression of anisotropic open-cell elastic foams

An Analytical Stress-Strain Model for Open-Cell Metal Foam

Predicting the Elastic Properties of Closed-Cell Aluminum Foams: a Mesoscopic Geometric Modeling Approach

High fidelity simulation of the mechanical behavior of closed-cell polyurethane foams

Analysis of Defects on the Compressive Behaviors of Open-Cell Metal Foams Through Models Using the FEM

Study of Cell Irregularity Effects on the Compression of Closed-Cell Foams

Modification and Verification of the Deshpande–Fleck Foam Model: A Variable Ellipticity

THEORETICAL STUDIES ON MECHANICAL MODELS OF LOW DENSITY FOAM