Abstract:An ultrasonic simulation technique based on the direct fluid model is proposed as an alternative to the analogous experimental technique to determine the tortuosity and characteristic lengths for high pore-density foams. It is beneficial as it reduces cost and almost eliminates the signal-to-noise issues encountered in the experiment. The proposed method is demonstrated for periodic microlattices with three different unit-cell configurations, 75%-90% porosity, and a pore size of about 200 microns. The technique is also applicable to high-resolution computed tomography (CT) scans of open-cell foams with a priori unknown microporous structure. An acoustic simulation software, ACTRAN® (Hexagon AB, Stockholm, Sweden), is used to model and perform analysis of the ultrasonic pulse propagation through the foam. Based on through-transmission by foam saturated with two different mediums, the tortuosity, and characteristic lengths are estimated from the high-frequency asymptotic behavior of the square of the propagation index (Nr2) versus the inverse square root of frequency (1/f). The predicted parameters are validated by comparing them with those determined by solving the electric conduction boundary value problem for the same configuration. Further, detailed parametric sensitivity analysis reveals the sensitivity of the Johnson-Champoux-Allard parameters to errors in Nr2 and so the effect of these errors on the acoustic absorption behavior of the rigid porous sample.

A numerical study of the elastic properties of low density open-cell foams with tetrakaidecahedral cells

Study on basic cells of new polyhedron spatial frames

A Numerical Study on the Large Deformations of Polymer Foams with Spherical Pores

Large Stiffness Thermoformed Open Cell Foams with Auxeticity

Mechanical Performance of Polystyrene Foam (EPS): Experimental and Numerical Analysis

Three-dimensional modeling of the mechanical property of linearly elastic open cell foams

NUMERICAL ANALYSIS OF THE CREEP AND STRESS RELAXATION OF LOW DENSITY OPEN-CELL FOAMS

Impact Properties of Uniaxially Thermoformed Auxetic Foams

THE MECHANICAL BEHAVIORS OF CLOSED-CELL ALUMINUM-ALLOY FOAMS WITH SPHERICAL PORES

Influence of Cell Wall Material and Cell Numbers on Mechanical Properties of Closed-Cell Aluminum Foams

High fidelity simulation of the mechanical behavior of closed-cell polyurethane foams

Micro-CT in the mechanical properties and energy absorption of closed-cell aluminium foam

A new modelling method for open cell foam structure based on centroidal and capacity constraint power diagram

Predicting the Elastic Properties of Closed-Cell Aluminum Foams: a Mesoscopic Geometric Modeling Approach

Dynamic mechanical properties of closed-cell aluminum foams with uniform and graded densities

Shear Stiffness and Energy Absorption of Auxetic Open Cell Foams as Sandwich Cores

Multiaxial creep of low density open-cell foams

Microstructure-based modeling to characterize low pore density open-cell foams and its experimental validation

Impact response of additively manufactured density-graded open-cell foams

Characterization of rigid open-cell foams using direct ultrasonic simulation

On Crushing Response of the Three-Dimensional Closed-Cell Foam Based on Voronoi Model