Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

Fully Differential CMOS LNA and Down-Conversion Mixer for 3-5 GHz MB-OFDM UWB Receivers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A group-selected and gain controllable CMOS active mixer for UWB applications

A Gm-boosted and current peaking wideband merged LNA and mixer

A Robust Cmos Rf Front-End Design for 3.1-4.8Ghz Mb-Ofdm Uwb System

A 3.1–4.8 GHz CMOS receiver for MB-OFDM UWB

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

A Monolithic 3.1-4.8 GHz MB-OFDM UWB Transceiver in 0.18-Μm CMOS

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A Single-in-differential-out CMOS RF Front-End for UWB 6&#x2013;9ghz Applications

A 6.2–9.5 GHz UWB receiver for WiMedia MB-OFDM

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

Low Power 0.18&#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Fully Differential CMOS LNA and Down-Conversion Mixer for 3-5 GHz MB-OFDM UWB Receivers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A group-selected and gain controllable CMOS active mixer for UWB applications

A Gm-boosted and current peaking wideband merged LNA and mixer

A Robust Cmos Rf Front-End Design for 3.1-4.8Ghz Mb-Ofdm Uwb System

A 3.1–4.8 GHz CMOS receiver for MB-OFDM UWB

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 0.13&amp;#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

A Monolithic 3.1-4.8 GHz MB-OFDM UWB Transceiver in 0.18-Μm CMOS

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A Single-in-differential-out CMOS RF Front-End for UWB 6&amp;#x2013;9ghz Applications

A 6.2–9.5 GHz UWB receiver for WiMedia MB-OFDM

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

Low Power 0.18&amp;#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A 0.13μm CMOS UWB Receiver Front-End Using Passive Mixer

A Single-in-differential-out CMOS RF Front-End for UWB 6–9ghz Applications

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver