Abstract:Single crystal beams made by (111)-oriented Si micromachining are usually anchored to the substrate directly. It is difficult to use the beams as resonators, since they are electrically connected to the substrate. This paper presents a modified process to fabricate single crystal nano beams which are electrically isolated from the substrate. In this process, the single crystal nano beams are fully released from the substrate and mechanically supported by metal wires, which also serve as electrical connections. The metal wires are much stiffer than the beams and do not degrade the mechanical properties of the beam according to simulations. The length and width of the beams are determined by photolithography. The thickness of the beam and the gap between the beam and the substrate are determined by the dry etching and KOH etching processes. The influence of KOH etching on the beam thickness is documented through ongoing experiments. At present, the double clamped beams and the cantilever beams have been fabricated. The thinnest beam to date was measured to be 47 nm. The resistance between the beam and the substrate was measured to be 214GΩ, while the resistance of a 147 nm-thick beam was measured to be 816 Ω. The surface roughness of the (111) plane is also discussed. The RMS surface roughness of the nano beam was measured to be 1.08 nm in an area of 5 μm × 5 μm, which was etched with 45%wt. KOH at 50°C.

Fabrication of the Isolated Nano-Beams in the Normal (111) Si Wafers with Koh Etching

A novel method to fabricate single crystal nano beams with (111)-oriented Si micromachining

Studies on Several Methods of Fabrication of Nano-Beams Based on MEMS

Silicon Nano-Wires Fabricated by Thermal Evaporation of Silicon Wafer

Silicon Nano-Wire Fabricated by Boe Silicon Etching

Array-orderly single crystalline silicon nano-wires

Fabrication Method of Silicon Nanostructures by Anisotropic Etching

N-Type Area of PN Junction Etched in BOE Solution

Fabrication and Characterization of Al Nanomechanical Resonators for Coupling to Nanoelectronic Devices

Fabrication Of Suspended Periodic Nanostructure By Focused Ion Beam Induced Material Migration And Rayleigh-Plateau Instability

Selective etching of n-type silicon in pn junction structure in hydrofluoric acid and its application in silicon nanowire fabrication.

OS1503 Development of Highly Ordered Silicon Nanowire Array

Engineering Island-Chain Silicon Nanowires Via a Droplet Mediated Plateau-Rayleigh Transformation

Fabrication of Vertically Stacked Single-Crystalline Si Nanowires Using Self-Limiting Oxidation

Dispersion, Refinement, and Manipulation of Single Silicon Nanowires

Single wafer fabrication of a symmetric double-sided beam-mass structure using DRIE and wet etching by a novel vertical sidewall protection technique

Fabrication of compact collateral silicon nanowires based on continuously alternating deposition

Fabrication of Nanopore and Nanopore Arrays in Si Substrate by Wet Etching Method at Wafer Scale

Fabrication of Single‐Crystalline Silicon Nanowires by Scratching a Silicon Surface with Catalytic Metal Particles

Fabrication of Nanoslits with <111> Etching TSWE Method

Fabrication and Characterization of Self-Standing W-Nanodendrites on Insulator SiO/sub 2/ Substrate with Electron-Beam-induced Deposition in HVTEM