Abstract:Silicon nanowire arrays (SiNWs) were prepared by the two-step silver catalyzed chemical etching process. The influence of various factors such as deposition time of silver nanoparticles, etching process and post-treatment conditions on the morphology and structure of SiNWs were systematically investigated. Scanning electron microscopy (SEM), X-ray diffraction (XRD), Ultraviolet-Visible spectroscopy (UV-Vis) and Fourier-transform infrared spectroscopy (FTIR) were used to characterize the SiNWs. The results revealed the existence of a positive linear relationship between length and etching time, which could be used to control the length of the SiNWs. The length and diameter of the nanowires both gradually decreased as the duration of the post-treatment process increased. SiNWs can be obtained with better uniformity by optimizing the post-treatment duration. In addition, four different lengths of SiNWs with regular and uniform morphology were fabricated using the above controllable growth process. The results showed that the silver catalyst was completely removed after the as-obtained SiNWs were immersed into HNO3. All the as-prepared SiNWs showed a good light reflection performance, which was enhanced with increasing lengths of the arrays. The reflectance of the as-obtained SiNWs was found to be less than 1% within the range of the visible spectrum (300-800 nm). These results confirm that this simple fabrication method can help achieve controllable growth of SiNWs of desired sizes. (C) 2015 Elsevier Ltd. All rights reserved.

OS1503 Development of Highly Ordered Silicon Nanowire Array

G030084 Fabrication of High Density Cu Nanowire Array by Template Method and Its Evaluation

Array-orderly single crystalline silicon nano-wires

Preparation of Large-Area Uniform Silicon Nanowires Arrays through Metal-Assisted Chemical Etching

Fabrication and Properties of Large-Area Silicon Nanowire Arrays

J212025 Fabrication of Nanowire Surface Fastener on Flexible Substrate and Its Electrical and Mechanical Properties

Wafer-Scale, Highly-Ordered Silicon Nanowires Produced by Step-and-Flash Imprint Lithography and Metal-Assisted Chemical Etching

Wafer-scale Fabrication of Silicon Nanowire Arrays with Controllable Dimensions

Extended Arrays of Vertically Aligned Sub-10 Nm Diameter [100] Si Nanowires by Metal-Assisted Chemical Etching

Fabricating Vertically Aligned Sub-20 Nm Si Nanowire Arrays by Chemical Etching and Thermal Oxidation

Ordered Arrays Of Vertically Aligned [110] Silicon Nanowires By Suppressing The Crystallographically Preferred Etching Directions

Silicon Nano-Wires Fabricated by Thermal Evaporation of Silicon Wafer

Controllable Growth of Silicon Nanowire Arrays Fabricated by Two-Step Silver Catalyzed Chemical Etching

Fabrication of Silicon Nanowire Arrays with Controlled Diameter, Length, and Density

Fabrication and characterization of polycrystalline silicon nanowires with silver-assistance by electroless deposition

Fabrication of antireflective silicon nanowires array

Design Optimization and Antireflection of Silicon Nanowire Arrays Fabricated by Au-assisted Chemical Etching

Preparation and Characterization of Silicon Nanowire Arrays for Solar Cell

Fabrication of Conducting Si Nanowire Arrays

Wafer-scale Fabrication of Uniform Si Nanowire Arrays Using the Si Wafer with UV/Ozone Pretreatment

The fabrication of large-scale sub-10-nm core-shell silicon nanowire arrays