Abstract:An air-breathing micro direct methanol fuel cell (mu DMFC) with a water collecting and recycling cathode structure is presented in this paper. The mechanism of water generation in cathode and water collection from the cathode is studied. The capillary channels with hydrophilic surface are designed along the ribs of the air-breathing cathode window to collect excessive water. The collected water is then released via an exhaust pipe. Microfabrication techniques, including double-side lithography and KOH etching, are used to fabricate the anode and cathode plates of the mu DMFC on the same silicon wafer simultaneously. The silicon plate surface is treated by low temperature oxygen plasma to improve the hydrophilicity. The mu DMFC with the water collecting and recycling structure and the regular one without, both with an active area of 7.8 x 7.8 mm(2), are assembled and characterized. Experimental results show that the maximum power density and current density of the both mu DMFCs are more than 10 mW cm(-2) and nearly 100 mA cm(-2) at room temperature, respectively. After both mu DMFCs operate at 0.15 V (about 60 mA cm(-2) at room temperature) for 1 h, the outputs of the prototype with water collecting and recycling structure decrease to about 9.7 mW cm(-2) and 95 mA cm(-2) only, while that of regular one decrease to 9 mW cm(-2) and 75 mA cm(-2). The water is collected by the exhaust pipe in evidence. As such, it would be possible to recycle the water from cathode to anode. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Performance Research of a Silicon-Based Micro Direct Methanol Fuel Cell

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

A Silicon-Based Micro Direct Methanol Fuel Cell with Microblocks in Anode Structure

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

A Monolithic Integrated Micro Direct Methanol Fuel Cell Based on Sulfo Functionalized Porous Silicon

Design and fabrication of a silicon-based micro direct methanol fuel cell stack

An Air-Breathing Micro Direct Methanol Fuel Cell with 3D KOH-Etched Cathode Structure

An Air-Breathing Micro Direct Methanol Fuel Cell Stack Employing a Single Shared Anode Using Silicon Microfabrication Technologies

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells

Miniaturized silicon-based direct methanol fuel cell

A Micro Direct Methanol Fuel Cell Using PDMS Assembly Technology

Development of MEMS-based direct methanol fuel cell with high power density using nanoimprint technology

A Silicon-Based Micro Direct Methanol Fuel Cell Stack with Compact Structure and PDMS Packaging

A micro-direct methanol fuel cell stack with optimized design and microfabrication

Passive Fuel Delivery Based on Hydrophobic Porous Silicon for Micro Direct Methanol Fuel Cells

A Novel Proton Exchange Membrane Based on Sulfo Functionalized Porous Silicon for Monolithic Integrated Micro Direct Methanol Fuel Cells

Development of Integrated Thermally Autonomous Reformed Methanol-Proton Exchange Membrane Fuel Cell System

A Neat Methanol Fed Passive DMFC with a New Anode Structure

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming