Abstract:A novel simultaneous boron and phosphorus diffusion technique is presented to produce simple, high‐efficiency n+pp+ silicon solar cells in one thermal cycle. This technique uses boron and phosphorus spin‐on dopant films to fabricate limited solid doping sources out of dummy silicon wafers. This approach results in the delivery of a fixed dose of P2O5 or B2O3 to the diffused sample. The resulting diffusion glass is extremely thin (∼60 Å), which allows for the in situ growth of a passivating thermal oxide without increasing the solar cell reflectance. Reverse saturation current density (Jo) measurements show that the in situ oxide passivation for a light boron and phosphorus diffusion provides excellent passivation properties, resulting in Jo values in the 100 fA/cm2 range. Measurements of the bulk minority carrier lifetime show that by fabricating separate boron solid sources, trace impurities in the spin‐on dopant film are not transported to the diffused sample. This filtering action is shown to result in bulk lifetimes in excess of 1 ms for silicon doped indirectly from the source wafers but gives much lower lifetimes (∼6 μs) for the wafers on which the boron spin‐on film was directly applied. This process was validated by fabricating in situ oxide passivated, n+pp+ solar cells in one high‐temperature cycle incorporating several high‐efficiency features including surface texturing and a back side reflector, resulting in confirmed efficiencies in the 19–20% range. © 1999 The Electrochemical Society. All rights reserved.

Monocrystalline silicon solar cells fabricated by rapid thermal

Monocrystalline Silicon Solar Cells Fabricated by Rapid Thermal Processing

Rapid Thermal Process to Fabricate Sb 2 Se 3 Thin Film for Solar Cell Application

CRYSTALLINE SILICON THIN FILM SOLAR CELLS PREPARED BY RAPID THERMAL CHEMICAL VAPOR DEPOSITION ON LOW COST SUBSTRATE

Crystallization of amorphous silicon thin films: The effect of rapid thermal processing pretreatment

Modulation of Atomic-Layer-deposited Al2O3 Film Passivation of Silicon Surface by Rapid Thermal Processing

Ultrafast Random‐Pyramid Texturing for Efficient Monocrystalline Silicon Solar Cells

Enhanced Electron Transport at the N+ Poly-Si/LiF/Al Interface in N-Topcon Silicon Solar Cells

Rapid Thermal Annealing Process for Se Thin-Film Solar Cells.

Effects of Rapid Thermal Processing on Oxide Precipitation in Conventional and Nitrogen‐doped Czochralski Silicon

Effect of rapid thermal annealing on photovoltaic properties of silicon solar cell fabricated by one-step laser doping in liquid

Effect of Rapid Thermal Processing on Oxygen Precipitation in Czochralski Silicon Subjected to Simulating CMOS Thermal Processing

Crystalline Silicon Heterojunction Solar Cell with 81.6% Fill Factor, Deposited by Physical Vapour Deposition Methods Only

Effects of Rapid Thermal Processing on Oxygen Precipitation in Czochralski Silicon Wafer

Effect of Rapid Thermal Processing on High Temperature Oxygen Precipitation Behaviour in Czochralski Silicon Wafer

Improvement of conversion efficiency of multicrystalline silicon solar cells by incorporating reactive ion etching texturing

High-efficiency Multicrystalline Silicon Solar Cells using Standard High-temperature, Float-zoned Cell Processing

Rapid Thermal Annealing and Hydrogen Passivation of Polycrystalline Silicon Thin-Film Solar Cells on Low-Temperature Glass

A Novel Processing Technology for High‐Efficiency Silicon Solar Cells

Small Pyramidal Textured Ultrathin Crystalline Silicon Solar Cells with Double-Layer Passivation.

Structural Properties of Polycrystalline Silicon Films Formed by Pulsed Rapid Thermal Processing